Instruction Manual

Safety Practices
3606 Rev 11/99
13
DO NOT
by-pass or disconnect any electrical or hydraulic circuits.
Consult the
Sky Trak
service department or your
Sky Trak
distributor if
any circuit is malfunctioning.
DO
check for frayed or cut seat belt webbing, damaged buckles or loose
mounting brackets. Replace immediately if required.
ALWAYS
wear a seat belt when operating the vehicle.
DO
check tire pressure on all four tires. Add air if required.
DO
check the condition of all four rims. Check for bent flanges and/or
bead mounting areas.
DO NOT
operate this vehicle unless all protective covers and guards
are in place and secure. These devices are installed on the vehicle for
your safety and protection.
DO
check the parking brake operation. Repair immediately if required.
DO
keep all non-skid surfaces clean and free of debris. Replace if worn,
damaged or missing.
DO
check the condition of important decals. Replace decals if missing,
damaged or illegible. Figures 1-4 on the following pages show the
proper location of the decals. Figure 1 (page 14) & Figure 2 (page 15)
represent vehicles with Work Order No. 06148 thru 45611. Figure 3
(page 16) & Figure 4 (page 17) represent vehicles with Work Order No.
45612 and After. The Work Order No. is stamped into the serial number
plate located on the front of the frame.
Equipment Considerations
WARNING
DO NOT
modify or alter (weld, drill, etc.) any part of this vehicle without
consulting
Sky Trak
. Modifications can weaken the structure creating a
hazard that can cause injury or death.
Safety Practices
3606 Rev 11/99
13
DO NOT
by-pass or disconnect any electrical or hydraulic circuits.
Consult the
Sky Trak
service department or your
Sky Trak
distributor if
any circuit is malfunctioning.
DO
check for frayed or cut seat belt webbing, damaged buckles or loose
mounting brackets. Replace immediately if required.
ALWAYS
wear a seat belt when operating the vehicle.
DO
check tire pressure on all four tires. Add air if required.
DO
check the condition of all four rims. Check for bent flanges and/or
bead mounting areas.
DO NOT
operate this vehicle unless all protective covers and guards
are in place and secure. These devices are installed on the vehicle for
your safety and protection.
DO
check the parking brake operation. Repair immediately if required.
DO
keep all non-skid surfaces clean and free of debris. Replace if worn,
damaged or missing.
DO
check the condition of important decals. Replace decals if missing,
damaged or illegible. Figures 1-4 on the following pages show the
proper location of the decals. Figure 1 (page 14) & Figure 2 (page 15)
represent vehicles with Work Order No. 06148 thru 45611. Figure 3
(page 16) & Figure 4 (page 17) represent vehicles with Work Order No.
45612 and After. The Work Order No. is stamped into the serial number
plate located on the front of the frame.
Equipment Considerations
WARNING
DO NOT
modify or alter (weld, drill, etc.) any part of this vehicle without
consulting
Sky Trak
. Modifications can weaken the structure creating a
hazard that can cause injury or death.