Manual

Model 10054 Rev 3/02

Operation

To pick a load, tilt the carriage forward so the forks hang freely on the fork

shaft. Move the forks inward or outward on the fork shaft so that they are

aligned with the openings in the pallet. Tilt the carriage back and extend the

boom slowly so the forks slide into the openings in the pallet. Raise the

boom so that the load is lifted.

To carry a load, position the boom so that the load is as low as possible and

the travel area is visible to the operator.

Before placing the load, determine whether the outriggers are to be in the

raised or lowered position. Then use the capacity chart to determine safe

boom extension range for the applicable load. To place a load, align the

forks at the level the load is to be placed and then extend the boom slowly

until the load is just above the area where it is to be placed. Lower the boom

until the pallet rests in position and the forks are free to retract. Retract the

forks slowly

from under the load.

How To Pick, Carry & Place A Load