Manual

Test Procedures
183
Model 10054 Rev 3/02
Step 4
a. Put the travel select lever in the (F) FORWARD position and the
gear select lever in the first gear position.
b. Attempt to accelerate the vehicle. The vehicle should not move.
c. If the vehicle attempts to move, STOP
andhavethesystem
repaired before using the vehicle again.
Step 5
a. Attempt to frame sway the vehicle to the right and left, it should
frame sway but at a slower
speed than normal.
b. The Stabil-TRAK light should remain ON.
c. Return the vehicle to a level position.
Step 6
a. Place the travel select lever in the (N) NEUTRAL position, move
the neutral lock lever to NEUTRAL LOCK position.
b. Fully retract the boom.
c. Raise the outriggers.
d. Engage the parking brake switch, shut OFF the engine and
remove the key.
e. Exit the vehicle using the hand holds.
If steps 1 through 5 prove positive, the Boom/Outrigger Interlock System is
functioning properly and the vehicle can be returned to service. If any of
these steps indicate that the Boom/Outrigger Interlock System is not
functioning properly, contact your local OmniQuip Authorized Service
Center (ASC) immediately to repair the system.
Test Procedures
183
Model 10054 Rev 3/02
Step 4
a. Put the travel select lever in the (F) FORWARD position and the
gear select lever in the first gear position.
b. Attempt to accelerate the vehicle. The vehicle should not move.
c. If the vehicle attempts to move, STOP
andhavethesystem
repaired before using the vehicle again.
Step 5
a. Attempt to frame sway the vehicle to the right and left, it should
frame sway but at a slower
speed than normal.
b. The Stabil-TRAK light should remain ON.
c. Return the vehicle to a level position.
Step 6
a. Place the travel select lever in the (N) NEUTRAL position, move
the neutral lock lever to NEUTRAL LOCK position.
b. Fully retract the boom.
c. Raise the outriggers.
d. Engage the parking brake switch, shut OFF the engine and
remove the key.
e. Exit the vehicle using the hand holds.
If steps 1 through 5 prove positive, the Boom/Outrigger Interlock System is
functioning properly and the vehicle can be returned to service. If any of
these steps indicate that the Boom/Outrigger Interlock System is not
functioning properly, contact your local OmniQuip Authorized Service
Center (ASC) immediately to repair the system.