Manual

182
Model 10054 Rev 3/02
Test Procedures
To test the function of the Boom/Outrigger Interlock System perform the
“Stabil-TRAK System Test” begining on page 178 before performing the
following test.
System Test
Step 1
a. Placethevehiclewithnoloadonaflat,levelhardsurfacesuch
as blacktop or concrete.
b. Fasten your seat belt.
Step 2
a. With outriggers in the raised position and the boom in a hori-
zontal position.
b. Extend the boom. The boom should extend until the letter “E”
appears and then should STOP. If the boom extends beyond
letter “F,” fully retract the boom and have the system repaired
before using the vehicle again.
c. Attempt to frame sway the vehicle to the right and left, it should
frame sway normally.
Step 3
a. Lower both outriggers to the ground (DO NOT lift the front
wheels of the vehicle off the ground at this time).
b. With the boom still in a horizontal position extend the boom.
The Stabil-TRAK light should come ON somewhere after the
letter “E” has appeared and remain ON while the boom extends
to full extension.
c. Attempt to raise both outriggers, they should not raise. If the
outriggers raise, STOP
and retract the boom and have the sys-
tem repaired before using the vehicle again.
d. If the outriggers could not be raised, attempt to lower the outrig-
gers fully until the front wheels are off the ground, the outrig-
gers should lower.
Boom/Outrigger Interlock System Test
WARNING: DO NOT operate this vehicle unless you are in
the seat with the seat belt fastened around you. Death or serious
personal injury could result if the belt is not securely fastened.
182
Model 10054 Rev 3/02
Test Procedures
To test the function of the Boom/Outrigger Interlock System perform the
“Stabil-TRAK System Test” begining on page 178 before performing the
following test.
System Test
Step 1
a. Placethevehiclewithnoloadonaflat,levelhardsurfacesuch
as blacktop or concrete.
b. Fasten your seat belt.
Step 2
a. With outriggers in the raised position and the boom in a hori-
zontal position.
b. Extend the boom. The boom should extend until the letter “E”
appears and then should STOP. If the boom extends beyond
letter “F,” fully retract the boom and have the system repaired
before using the vehicle again.
c. Attempt to frame sway the vehicle to the right and left, it should
frame sway normally.
Step 3
a. Lower both outriggers to the ground (DO NOT lift the front
wheels of the vehicle off the ground at this time).
b. With the boom still in a horizontal position extend the boom.
The Stabil-TRAK light should come ON somewhere after the
letter “E” has appeared and remain ON while the boom extends
to full extension.
c. Attempt to raise both outriggers, they should not raise. If the
outriggers raise, STOP
and retract the boom and have the sys-
tem repaired before using the vehicle again.
d. If the outriggers could not be raised, attempt to lower the outrig-
gers fully until the front wheels are off the ground, the outrig-
gers should lower.
Boom/Outrigger Interlock System Test
WARNING: DO NOT operate this vehicle unless you are in
the seat with the seat belt fastened around you. Death or serious
personal injury could result if the belt is not securely fastened.