Manual

ManualsBrandsSkyTrak ManualsSpecial machinery10054 Operation Manual

171

172

173

174

175

176

177

178

179

180

178

Model 10054 Rev 3/02

Test Procedures

To test the function of the Stabil-TRAK system, read the Stabil-TRAK

system test instructions on this page and follow steps 1 thru 9 of the Stabil-

TRAK System Test Procedure starting on page 179.

Stabil-TRAK System Test Instructions

• Test the Stabil-TRAK system with the vehicle on a level surface.

• Remove any attachment from the quick attach before performing

the test.

•DONOTextend the boom at any time during the test. Perform the

test with the boom fully retracted.

•DONOTraise the boom above 60° for steps 3 thru 6.

•DONOTraise the boom above 45° for steps 7 thru 9.

• Test vehicles with outriggers in the RAISED position.

• Follow steps 1 thru 9 of the Stabil-TRAK system test procedure

exactly

as written.

IMPORTANT! If the Stabil-TRAK light goes OFF and the front left tire lowers

to the ground at any time during steps 4 thru 7, the test was not performed

properly or the Stabil-TRAK system is not functioning properly. Carefully

repeat the steps starting with step 1.

If the Stabil-TRAK light goes OFF and the front left tire lowers to the ground

consistently during steps 4 thru 7, the Stabil-TRAK system is not functioning

properly and the test should be stopped immediately

. Contact your

OmniQuip A uthorized Service Center (ASC) immediately to repair the

system.

Stabil-TRAK System Test

178