Manual

General Maintenance
139
Model 10054 Rev 3/02
3. Allow the transmission to cool.
4. Place a receptacle under the transmission drain plug (Figure 95).
Remove the drain plug and allow the Universal Tractor Fluid to
drain into the receptacle. Transfer the used oil into a suitable con-
tainer with a cover and label the container as used oil. Dispose of
properly.
5. Clean and re-install the drain plug into the transmission housing.
6. Remove the filter from the filter mount on the front side of the trans-
mission (Figure 95). Dispose of the filter properly. Clean the mating
surface where the filter mounts.
7. Apply a thin film of clean Universal Tractor Fluid to the new filter
gasket. Carefully install a new filter.
Figure 95
8. Remove the dipstick and fill with Universal Tractor Fluid approxi-
mately 2.6 gallons (9,8 liters). Re-install the dipstick
9. Check the transmission level and add Universal Tractor Fluid as
required following the procedures outlined in “Transmission Oil
Level Check” on page 137.
10. Reassemble the transmission covers and secure in place with the
six capscrews or hex nuts, washers and lockwashers. Tighten
securely.
OH2380
Transmission
Drain Plug
Transmission
Filter
Transmission
Dipstick and Fill
General Maintenance
139
Model 10054 Rev 3/02
3. Allow the transmission to cool.
4. Place a receptacle under the transmission drain plug (Figure 95).
Remove the drain plug and allow the Universal Tractor Fluid to
drain into the receptacle. Transfer the used oil into a suitable con-
tainer with a cover and label the container as used oil. Dispose of
properly.
5. Clean and re-install the drain plug into the transmission housing.
6. Remove the filter from the filter mount on the front side of the trans-
mission (Figure 95). Dispose of the filter properly. Clean the mating
surface where the filter mounts.
7. Apply a thin film of clean Universal Tractor Fluid to the new filter
gasket. Carefully install a new filter.
Figure 95
8. Remove the dipstick and fill with Universal Tractor Fluid approxi-
mately 2.6 gallons (9,8 liters). Re-install the dipstick
9. Check the transmission level and add Universal Tractor Fluid as
required following the procedures outlined in “Transmission Oil
Level Check” on page 137.
10. Reassemble the transmission covers and secure in place with the
six capscrews or hex nuts, washers and lockwashers. Tighten
securely.
OH2380
Transmission
Drain Plug
Transmission
Filter
Transmission
Dipstick and Fill