Owner's Manual

Rev. 2/1/06 Page 6 of 8
FREQUENCY (DISTANCE) ADJUSTMENT PROCEDURE
TRANSMITTER ADJUSTMENT – RECOMMENDED ADJUSTMENT
1. To adjust at the transmitter, use a small slotted screwdriver.
2. Remove the small sticky DOT on the back top of the transmitter.
3. Turn the adjustment screw clock-wise about 5 degrees or a maximum of less than 1/8 turn.
this should correct the distance problem.
4. If that does not correct the problem, return adjustment screw to original position and then
turn adjustment screw counter-clockwise.
NOTE: This adjustment is like tuning your radio. If you keep turning the adjustment screw, in either
direction, you will go past the proper setting (tuning).
SPECIFICATIONS
ELECTRICAL LOAD RATINGS
FOR INDOORS USE ONLY
LISTED
ELECTRICAL RATINGS
13F7 Input: 120 VAC; 60 Hz
Appliance Output: 2.5 A; 24 VAC/60Hz or 24 VDC
Control
BATTERIES: Transmitter (2) 1.5V Alkaline (AAA)
Remote Receiver 110-120 VAC; 60 Hz
Operating Frequency: 303.875 MHZ
FCC ID No.’s: transmitter –K9L SP1001TH receiver – K9L1410RX
Canadian ISC ID No.’s: transmitter –2439A-SP1001TH receiver – 2439A-1410RX
FOR TECHNICAL U.S. INQUIRIES CANADIAN INQUIRIES
SERVICE, CALL: 888/672-8929 or 877/472-3923
260/459-1703
Website: skytechsystem.com
MANUFACTURED EXCLUSIVELY FOR SKYTECH II, INC
FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED
MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE
EQUIPMENT.
Transmitter
Back
Remove
DOT for
Access to
Screw