Owner's Manual

Rev. 2/1/06 Page 3 of 8
RECEIVER
When plugged into a standard 110-120 VAC receptacle, the remote receiver
operates on commands from the transmitter or from the slide switch on the face
of the receiver (This switch is to be used during a power outage to operate the
appliance manually). The remote receiver is manufactured with a “dry contact”
relay in its circuitry that operates like an on/off switch, however, no power or
current passes from the 110-120 VAC input side to the wires leading from the
output side of the remote receiver.
This 1410T/LCD-A remote control system can be used in simplified installations
to control a millivolt gas valve without any additional relays or components.
LOCATING THE RECEIVER
PROTECTION FROM EXTREME HEAT IS VERY IMPORTANT. Like any piece of electronic equipment, the remote receiver should be
kept away from temperatures exceeding 130
0
F. Exposure to extreme temperatures can damage the electronic components or cause
the plastic case to become deformed and is not covered under warranty.
WIRING INSTRUCTIONS
A qualified electrician or a gas technician who is familiar with the gas appliance and gas valves that will be operated by this remote
should install the remote control system. Incorrect wiring connections WILL cause damage to the gas valve or electronic module
operating the gas appliance and may also damage the remote receiver.
WIRING MILLIVOLT VALVES
The remote receiver is to be connected to the millivolt valve.
Connect one of the (2) 18 gauge wires from the 1410T/LCD-A receiver to the TH terminal
and the other to the THTP terminal on the terminal block on the millivolt gas valve.
Operation of the remote receiver is similar to that of a thermostat in that both turn the gas
valve on and off based on input signals. A thermostat’s input signals are different
temperatures. The remote receiver’s input signals come from the transmitter.
To 120VAC input
Slide
Switch
OFF
REMOTE
ON
LEARN
VALVE
ANTENNA
REMOTE RECEIVER
Dry Contact
(2) 1/4” female
Connectors
WARNING
THIS REMOTE CONTROL SYSTEM MUST BE INSTALLED EXACTLY AS OUTLINED IN THESE INSTRUCTIONS. READ ALL
INSTRUCTIONS COMMPLETELY BEFORE ATTEMPTING INSTALLATION. FOLLOW INSTRUCTIONS CAREFULLY DURING
INSTALLATION. ANY MODIFICATION OF THIS REMOTE CONTROL OR ANY OF ITS COMPONENTS WILL VOID THE WARRANTY
AND MAY POSE A FIRE HAZARD.
1 2 3 4 5 6
REMOTE RECEIVER
TERMINAL BLOCK
ON MILLIVOLT
GAS VALVES
TH
TP
TP
TH
THERMOPILE/
PILOT LIGHT
110/120VAC
input