Installation and Operating Instructions

Model: 8001TX
REV. 1-13-21 Page 3
LEARNING TRANSMITTER TO RECEIVER
Each transmitter uses a unique security code. It will be
necessary to press and release the LEARN button on the
receiver to accept the transmitter security code upon initial
use or if a replacement transmitter is purchased from your
dealer or the factory. Refer to the LEARNING SECTION of
the instructions provided with the Skytech receiver you wish
to control.
Locate the LEARN button on the receiver. Then press and
release the LEARN button. When you release the LEARN
button on the receiver you will hear a “beep”. Next,
activate the Smart Plug via voice or Smart Phone app. The
green LED light on top of the Smart Adapter Transmitter
will illuminate and send a RF signal to the receiver and the
receiver will emitt three “beeps” conrming the LEARNING
process is complete. At the same time the gas appliance
will turn ON.
S
m
a
r
t
P
l
u
g
P
h
o
n
e
C
h
ar
g
e
r
Ho
me
O
u
tl
e
t
Smart Adapter
Transmitter
Green LED
Light
TROUBLE SHOOTING
If you encounter problems with your replace system, the problem may be with the replace itself or it could be with the
remote. Review the replace manufacturer’s operation manual to make sure all connections are properly made. Then
check the operation of the remote in the following manner:
• Make sure the batteries are correctly installed in the RECEIVER. One reversed battery will keep receiver from
operating properly.
• See LEARNING TRANSMITTER TO RECEIVER section.
• Be sure Receiver and Transmitter is within 20-25-foot operating range.
• Keep receiver from temperatures exceeding 130º F. Battery life shortened when ambient temperatures are above
130º F.
• If receiver is installed in tightly enclosed metal surround, the operating distance will be shortened.