Installation and Operating Instructions
Model: 8001TX
REV. 1-13-21 Page 2
WARNING
This remote control system must be installed exactly as outlined in these instructions. Read all instructions completely
before attempting installation. Follow instructions carefully during installation. Any modications of the remote control or
any of its components will void the warranty and may pose a re hazard.
Do not connect any gas valve or electronic module directly to 110-120VAC power. Consult gas appliance manufacturer’s
instructions and wiring schematics for proper placement of all wires. All electronic modules are to be wired to
manufacturer’s specications.
The following wiring diagrams are for illustration purposes only. Follow instructions from manufacturer of gas valve and/
or electronic module for correct wiring procedures. Improper installation of electric components can cause damage to
electronic module, gas valve and remote receiver.
INSTALLATION INSTRUCTIONS
INSTALLING TRANSMITTER
Step 1: Ensure the Smart Plug (not supplied) is plugged
into a working outlet and it is working properly according to
the instructions supplied with the Smart Plug. The Smart
Plug can be tested by plugging a light or radio into the plug,
turning the light or radio ON and activating the Smart Plug
to conrm the Smart Plug operates properly.
Step 2: Unplug the light or radio from the Smart Plug and
insert a USB Phone adapter into the Smart Plug.
Note: The USB phone charger may be omitted if the Smart
Plug has a switchable USB outlet.
Step 3: Plug the “Smart Adapter Transmitter” into the USB
Phone adapter. Installation is now complete.
S
m
a
r
t
P
l
u
g
P
h
o
n
e
C
h
ar
g
e
r
Ho
me
O
u
tl
e
t
Smart Adapter
Transmitter
1. Smart Plug recieves
commands via WI-FI
or Bluetooth
2. Smart Plug powers
USB phone charger
3. Phone Charger energizes
“Smart Adapter”
transmitter and sends
(5VDC) ‘ON” command via
RF signal to Reciever
120VAC
120VAC
5DCV
SMART PLUG
(not supplied)
USB PHONE
CHARGER
SMART ADAPTER
TRANSMITTER
USB plug
(male Jack)
BASIC OPERATION