Installation Guide

REV.3/19-05 Page 6 of 16
2. Then press the UP
or DOWN button to select the DESIRED room
temperature. The highest SET temperature is 99
0
F (32
0
C). The
lowest SET temperature is 45
0
F (6
0
C).
3. The TRANSMITTER will “sense” the room temperature every two
minutes automatically turning the fireplace ON or OFF
thermostatically.
TEMPERATURE OVERRIDE
– (Operates only in PROGRAM mode)
The user may change the current SET temperature without changing
the programs stored in the transmitter’s memory. The OVERRIDE
feature will be automatically cancelled at the start of the next
PROGRAM PERIOD.
1. To change current SET TEMP, press the UP
or DOWN key.
(Setting will be cancelled automatically when next program period
begins.) The word OVERRIDE will appear over the SET frame on
the LCD.
2. To cancel temperature OVERRIDE, press SET
button.
TEMPERATURE HOLD
– (Operates only in PROGRAM
mode.)
The user may override the SET temperature during any period,
adjusting the SET temperature to a CONSTANT new SET/HOLD
temperature.
1. Press the UP
or DOWN button to change the SET temperature to
the level desired. The word OVERRIDE will appear in SET frame
on the LCD.
2. To HOLD the new temperature at a CONSTANT setting, push the
UP
and DOWN buttons TOGETHER to activate the HOLD function.
The word HOLD will appear over the SET frame and the word
OVERRIDE will disappear.
3. To cancel OVERRIDE or HOLD, press the SET
button or HOLD will
last until the next programmed period change.
TIME OF DAY DISPLAY
1. To check the current TIME of day, press the TIMER/TIME
button
on the transmitter for less than 1 second. The current TIME of day
will appear in the TIME/TEMP frame replacing the temperature
reading the TEMPERATURE will reappear in 15 seconds.
2. press the SET
button to cancel the display of the time.
SETTING THE COUNTDOWN TIMER
This remote control can operate with a built-in, countdown timer when
the transmitter is in the ON or THERMO mode (THERMO or ON must
be displayed on the LCD screen). DOES NOT operate in PROGRAM
MODE as times are pre-programmed into the transmitter.
1. Press the TIMER/TIME
button on the transmitter for more than 2
seconds. The word TIMER and 0:15 flash on the LCD screen.
2. Press the UP
or DOWN button on the transmitter to begin
advancing through each of the countdown time options. Available
MANUAL CHECK OF THERMO OPERATION
The operation of the Thermo setting can be checked on demand by adjusting the SET temperature 2
0
F above or below the room
temperature, which will cause the system to turn ON or OFF, respectively. Normally, however, the system will only respond to
temperature changes every two minutes. NOTE: if “SWING” number has been changed, then activation will occur at the new “SWING”
settin
g
.
3
TEMP
SET
WE
THERMO
ON
FLAME
TIMER
FAN
OFF
HI
HI
1
2
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
FAN
FLAME
2
1
TEMP
SET
MO
DAY
PROGRAM
OVERRIDE
ON
FLAME
FAN
OFF
HI
HI
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
FAN
FLAME
3
1,2
TEMP
SET
MO
DAY
PROGRAM
HOLD
ON
FLAME
FAN
OFF
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
FAN
FLAME
3
2
TIME
SU
AM
OFF
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
FAN
FLAME