Installation Guide

REV.3/19-05 Page 3 of 16
SETTING THE CURRENT DAY OF THE WEEK
1. Following Step 3 on the previous page, the symbol SU will begin
flashing on the LCD screen.
2. To change to the CURRENT day of the week, press the AHEAD
or
BACK
button on the front of the transmitter.
3. After setting/confirming the current Day of the week, press the SET
button on the front of the transmitter.
NOTE:
You will need to press the SET button, confirming SU, if that is
the current day.
SETTING THE CURRENT HOUR AND MINUTES
1. Following Step 3 above, the HOUR digits will begin flashing in the
TIME frame on the LCD screen.
2. To set the current HOUR, press the UP
or DOWN button setting the
HOUR for the corresponding AM/PM time period.
3. After setting the current HOUR, press the SET
button on the front
of the transmitter, and the MINUTE digits will begin flashing on the
LCD screen
4. To set the current MINUTES, press the UP
or DOWN button setting
the correct MINUTES.
5. After setting the HOURS and MINUTES, press the SET
button on
the front of the transmitter
SETTING THE FLAME CONTROLLER
1. Following step 5 above, two flames, words HI FLAME will begin
flashing on the LCD screen.
2. On this 3324R system press SET
this will set the flame controller to
HI/LO operation.
3. You can push the UP
or DOWN button setting HI/LO or
MODULATION on the LCD screen.
4. NOTE: The 3324R solenoid will only work when the flame
controller is set to HI/LO.
The initial set-up/programming of the transmitters is now complete. Be sure the slide-on battery cover is reinstalled and proceed to the
next step. The LCD screen will now display in its normal state.
PROGRAM OPERATION OF REMOTE CONTROL
BUILT –IN FACTORY PROGRAM
The transmitter has a factory program built in. Each day has been broken into
four periods and each period has its own starting time and temperature. A chart
of the built- in programs is at the left.
You may change any of the factory settings by following the procedures below.
Should you wish to return to the factory program, follow the procedures under
heading PROGRAM REVIEW or PROGRAM CANCELLATION depending on
which process you select.
DAY
PERIOD
TIME/TEMP
All 7 Days
MORN
6:00 AM 70
Factory-
Programmed
DAY
EVE
NIGHT
8:30 AM 60
3:00 PM 70
11:00 PM 63
3
2
TIME
SU
AM
OFF
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
FAN
FLAME
3
2
TIME
SU
AM
OFF
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
FAN
FLAME
TEMP
SET
WE
THERMO
ON
FLAME
FAN
OFF
HI
HI
1
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
FAN
FLAME