Installation Guide

REV.3/19-05 Page 2 of 16
12. FLAME – Single or double flame symbol indicates burner/valve is
operational.
13. HOLD – Displays when “programmed” SET temperature is overridden
and will hold that temperature until cancelled or next program period
change.
14. CP – Displays when CHILD PROOF “LOCK-OUT” is engaged.
Pressing the UP and TIMER buttons together, engages CP.
15. SWING- Displays in SET frame when setting TEMPERATURE
DIFFERENTIAL.
16. FAN – Indicates the fan is on (when fan blade displayed). OFF
indicates fan is not in operation.
FUNCTIONS
To operate the system, press the MODE button on the transmitter to select the operational
MODE desired.
1. ON indicates the system is on, either manually or thermostatically.
2. OFF indicates the entire system is turned off.
3. THERMO indicates the system will automatically cycle ON/OFF, depending on
programmed set temperature.
4. PROGRAM indicates the system will automatically cycle ON and OFF in the
programmed mode depending on the 7 day/4 period program that is in memory.
BUTTON SETTINGS
Flip down the plastic cover on the front of the transmitter to expose the “SET”
buttons. The flip
cover protects the SET
buttons from being changed accidentally. Close the cover after completing
the following settings/programming.
Flashing numbers on the display indicate the system is awaiting user input, such as using the UP
and DOWN
buttons to program a new setting. If no change is made to flashing digits within 15
seconds, the system will complete the procedure last programmed and reset the display to its
normal state.
INITIAL SET-UP PROGRAMMING OF TRANSMITTER
Follow the procedures below, upon FIRST USE of transmitter, setting the following program
options:
1. TEMPERATURE SETTING –
0
F (Fahrenheit) or
0
C (Celsius)
2. CURRENT DAY OF WEEK – SU, MO, TU, WE, TH, FR, SA
3. CURRENT TIME OF DAY – Hours and minutes
4. FLAME CONTROLLER – HI/LO solenoid
NOTE: Factory settings are NG,
0
F, and HI/LO FLAME CONTROL. On this
3324R system do not change.
To program settings, first remove the battery cover on the back of the transmitter. If you have not
already installed the 2-AAA batteries, this would be a good time to do so. Note the small push
button at the upper left side of the battery compartment. This is the button used to perform the
initial transmitter programming
. You will need to use a paper clip or sharp end of a pencil to
depress this button.
CHANGING THE TEMPERATURE SCALE
1. After pressing the small button in the battery compartment to start
the set up process the
0
F symbol will begin flashing on the LCD
screen.
2. To change
0
F to
0
C, press the UP or DOWN button on the front of
the transmitter.
3. After setting/confirming the preferred temperature SCALE, press
the SET
button on the front of the transmitter.
NOTE:
You will need to press the SET button, confirming
0
F if you
want the temperature readings to be in
0
F.
CAUTION: All wiring should be done by a qualified
electrician and shall be in compliance with local codes
and with the National Electric Code ANSI/NPFA No. 70-
current (in the United States), or with the current CSA
C22.1 Canadian Electric Code (in Canada).
SU
TEMP
FAN
OFF
OFF
ON OFF THERMO PROGRAM
Setting
Button
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
FAN
FLAME
3
2
TIME
SU
AM
OFF
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
FAN
FLAME