Installation Guide

ManualsBrandsSkytech ManualsFireplaces and FirepitsThermostatic and Programmable Wireless Fireplace Control System with Programmable Thermostat

REV.3/19-05 Page 13 of 16

TIMER

The countdown timer will operate in either the manual ON or THERMO mode. Once the fireplace system is in an operating mode, set

the countdown timer to turn off in 15 minutes. The timer function will allow operation to continue until the countdown “time” on the LCD

screen expires. After 15 minutes elapses, the system should turn OFF.

If you have any problems with operation, recheck your connections and ensure transmitter batteries are fully charged. If no problem is

found, contact the dealer where your purchased your fireplace/remote control.

GENERAL INFORMATION

MATCHING SECURITY CODES

Each transmitter can use one of 1,048,576 unique security codes. It may

be necessary to program the remote receiver to LEARN the

security code of the transmitter upon initial use

, if batteries are replaced, or if a replacement transmitter is purchased from your dealer

or the factory. When matching security codes, be sure slide button on the receiver is in the REMOTE position; the code will NOT

“LEARN” if the slide switch is in the ON or OFF position. Program the remote receiver to LEARN a new security code by pushing in the

LEARN button on the top of the remote receiver and then pressing the MODE button on the transmitter. A change in the beeping

pattern, at the receiver, indicates the transmitter’s code has been programmed into the receiver. When an existing receiver is matched

to a new transmitter, the new security code will overwrite the old one.

The microprocessor that controls the security code matching procedure is controlled by a timing function. If you are unsuccessful in

matching the security code on the first attempt, wait 1-2 minutes before trying again – this delay allows the microprocessor to reset its

timer circuitry – and try up to two or three more times.

CHILD-PROOF “LOCK –OUT”

–(CP)

This SKYTECH remote control includes a CHILD-PROOF “LOCK-OUT” feature that allows the user to “LOCK –OUT” operation of the

fireplace, from the TRANSMITTER.

SETTING “LOCK-OUT” – (CP)

1. To activate the “LOCK-OUT” feature, press and hold the UP

and

TIMER/TIME

buttons, together, for 5 seconds. The letters CP will

appear in the TEMP frame on the LCD screen.

2. To disengage the “LOCK-OUT”, press and hold the UP

and

TIMER/TIME

buttons, together for 5 seconds or more, and the

letters CP will disappear from the LCD screen and the transmitter

will return to its normal operating condition.

NOTE

: If the fireplace system is already operating in the ON, THERMO or PROGRAM MODES, engaging the “LOCK-OUT” will not

cancel the operating MODE. Engaging the “LOCK-OUT” prevents only the manual operation of the TRANSMITTER

. If in the auto

modes, the THERMO and/or PROGRAM operation will continue to operate normally. To totally “LOCK-OUT” the operation of the

TRANSMITTER’S operating signals, the transmitter’s MODE must be set to OFF.

THERMO FUNCTION

When the transmitter is in the THERMO mode, it should be kept away from direct sources of heat such as fireplaces, incandescent

lighting, and direct sunlight. Leaving the transmitter in direct sunlight, for example, will cause its heat-sensing diode to read the room

temperature higher than it actually is; if in THERMO mode, it may not turn on the appliance even if the ambient ROOM temperature is

below the SET temperature.

NITE

THERMO

1,2

TIME

FLAME

SET

FAN

OFF

DOWN

MODE

TIMER

TIME

SET

PROG

AHEAD

BACK

FAN

FLAME