Installation Guide

REV. 3/19/05 Page 6 of 14
TIME OF DAY DISPLAY
1. To check the current TIME of day, press the TIMER/TIME
button on the
transmitter for less than 1 second. The current TIME of day will appear in
the TIME/TEMP frame replacing the temperature reading.
2. The TEMPERATURE will reappear in 15 seconds, or you can press the SET
button to cancel the display of the time.
SETTING THE COUNTDOWN TIMER
This remote control can operate with a built-in, countdown timer when the
transmitter is in the ON or THERMO mode (THERMO or ON must be displayed
on the LCD screen). DO NOT operate in PROGRAM MODE as times are pre-
programmed into the transmitter.
1 Press the TIMER/TIME
button on the transmitter for more than 2 seconds.
The word TIMER and 0:15 flash on the LCD screen.
2 Press the UP
or DOWN button on the transmitter to begin advancing through
each of the countdown time options. Available countdown times are 15 min.,
30 min, 45 min, 1 hr, 1 hr 30 min, 2 hr, 2 hr 30 min, and each additional half
hour up to nine hours.
3 To set the TIMER press the SET
button on the transmitter. If the system is
ON, it will remain on until the “timer time” has expired. If the system is in
the THERMO mode, it will cancel ON and OFF as the room temperature
requires until the “timer time” has expired.
4 To cancel the TIMER operation, press the TIMER/TIME
button for more than
2 seconds.
OPERATIONAL NOTE:
When the TIMER is used in the
THERMO mode, the THERMO operation will discontinue only
when the “countdown time” has expired.
OPERATING FAN
( Operates only in ON/THERMO/ PROGRAM MODES)
This remote control system has the capability of operating a 110 VAC fan or
blower system that may
be included with your gas appliance. It only operates an
ON/OFF function for the fan/blower and cannot operate a variable speed
controller. When properly connected to the remote receiver, the fan will only go
ON or OFF by remote. You may still be able to vary the speed of the fan/blower
motor at the appliance
, but not remotely with the transmitter.
1. To turn the fan ON, press the FAN
button on the transmitter, When the fan is
operating, the fan blade will display.
2. Press FAN button to turn fan OFF, When the fan is off, OFF will display on
the LCD screen below the word FAN. When the transmitter is in the
THERMO or PROGRAM modes and the FAN button is pressed to ON, the
FAN will operate ON and OFF as the cycling of the THERMO or PROGRAM
occurs.
3. IF the Fan is in the OFF position, the fan will not operate until activated by
the FAN
button.
LOW/BATTERY INDICATOR
The word LOW outlined by a battery on the left side of the LCD screen will
appear when battery power has dropped significantly. At this time,
approximately two weeks of battery power remains until the transmitter
may experience partial or complete loss of functions. NOTE: A reversed
battery will activate the LOW battery icon.
TEMP
SET
WE
THERMO
HOLD
ON
FLAME
TIMER
LOW
FAN
1
TEMP
MO
PROGRAM
ON
FLAME
FAN
DAY
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
FAN
2
TIME
TU
THERMO
ON
FLAME
1
PM
FAN
OFF
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
FAN
3
TEMP
SET
WE
THERMO
ON
FLAME
TIMER
FAN
OFF
1
2
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
FAN