Installation Guide

REV 3/17/05 Page 9 of 14
WALL MOUNTING
Install 4 AA-size 1.5 ALKALINE batteries in the remote receiver. For best performance, remote receiver batteries should be factory fresh when
installed. Very little battery power is required to operate the remote receiver, but the electronics are tuned to operate best when battery output
is greater than 5.3 volts. Four new AA batteries should provide an output voltage of 6.0 to 6.2 volts. Be sure batteries are installed with the
(+) and (-) ends facing the correct direction.
To attach wall cover plate to receiver box:
1. Position the receiver as shown in diagram to the left with lower tab on
wall cover plate into groove of receiver (Make sure ADJ hole
and LEARN hole on cover plate properly aligns with remote receiver)
2. Pull receiver up and snap into top tab of cover plate.
3. Position the wall cover plate so the word ON is facing up.
4. Install the remote receiver into the plastic switch box using the two
long screws provided. Push the slide Button over the receiver slide
switch only after making sure the remote receiver has LEARNED the
transmitter’s security code (see MATCHING SECURITY CODES). NOTE: slide
5. Button covers both ADJ and Learn holes when properly installed.
NOTE: The remote receiver will only respond to the transmitter when the 3-position slide button on the remote receiver is in the
REMOTE position. If the system does not respond to the battery transmitter on initial use, see MATCHING
SECURITY CODES, and recheck battery positions in the remote receiver
.
HEARTH MOUNT
The remote receiver can be placed on the fireplace hearth or under the fireplace, behind the
control access panel. Position where the ambient temperature inside the receiver case does
not exceed 130
0
F.
NOTE: Slide Button is used for Hearth Mount applications.
WIRING INSTRUCTIONS
A qualified electrician or a gas technician who is familiar with the gas appliance and gas valves that will be operated by this remote should
install the remote control system. Incorrect wiring connections WILL cause damage to the gas valve or electronic module operating the gas
appliance and may also damage the remote receiver.
WIRING MILLIVOLT VALVES
The remote receiver is connected to the millivolt valve using the TH (thermostat) terminals on
the terminal block on the millivolt gas valve. Connect 18 gauge stranded or solid wires from
the remote receiver to the gas valve.
Operation of the remote receiver is similar to that of a thermostat in that both turn the gas
valve on and off based on input signals. A thermostat’s input signals are different
temperatures. The remote receiver’s input signals come from the transmitter.
Connect each of the two wires leading from the TH and TH/TP terminals on the millivolt gas
valve to either of the two wire terminals on the remote receiver. Normally it does not matter
which wires go to which terminal.
Remote Receiver
Cover Plate
(Rear View)
R
E
M
O
T
E
ON
OFF
LEARN
ADJ
.
REMOTE
ON
OFF
LEARN
ADJ.
WALL
Plastic Switch Box
Remote Receiver
Cover Plate
Receiver
Slide
Button
Wire terminals
Remote Receiver
Receiver
Slide
Button
REMOTE
OFF
ON
LEARN
ADJ.