Installation Guide

REV 3/17/05 Page 6 of 14
2. Then press the UP or DOWN button to select the DESIRED room
temperature. The highest SET temperature is 99
0
F ( 32
0
C ).
The lowest SET temperature is 45
0
F ( 6
0
C ).
3. The TRANSMITTER will “sense” the room temperature every two
minutes automatically turning the fireplace ON or OFF
thermostatically.
TEMPERATURE OVERRIDE
– (Operates only in PROGRAM mode)
The user may change the current SET temperature without changing
the programs stored in the transmitter’s memory. The OVERRIDE
feature will be automatically cancelled at the start of the next
PROGRAM PERIOD.
1. To change current SET TEMP, press the UP
or DOWN button
(Setting will be cancelled automatically when next program period
begins.) The word OVERRIDE will appear over the SET frame on
the LCD.
2. To cancel temperature OVERRIDE, press SET
button.
TEMPERATURE HOLD
– (Operates only in PROGRAM mode.)
The user may override the SET temperature during any period,
adjusting the SET temperature to a CONSTANT new SET/HOLD
temperature.
1. Press the UP
or DOWN button to change the SET temperature to
the level desired. The word OVERRIDE will appear in SET frame
on the LCD.
2. To HOLD the new temperature at a CONSTANT setting, push the
UP
and DOWN buttons TOGETHER to activate the HOLD
function.
The word HOLD will appear over the SET frame and the word
OVERRIDE will disappear.
3. To cancel OVERRIDE or HOLD, press the SET
button.
TIME OF DAY DISPLAY
1 To check the current TIME of day, press the TIMER/TIME
button
on the transmitter for less than 1 second. The current TIME of
day will appear in the TIME/TEMP frame replacing the
temperature reading.
2 The TEMPERATURE will reappear in 15 seconds, or you can
press the SET
button to cancel the display of the time.
SETTING THE COUNTDOWN TIMER
This remote control can operate with a built-in, countdown timer when
the transmitter is in the ON or THERMO mode (THERMO or ON must
be displayed on the LCD screen). DO NOT operate in PROGRAM
MODE as times are pre-programmed into the transmitter.
1 Press the TIMER/TIME
button on the transmitter for more than 2
seconds. The word TIMER and 0:15 flash on the LCD screen.
2 Press the UP
or DOWN button on the transmitter to begin
advancing through each of the countdown time options. Available
countdown times are 15 min., 30 min, 45 min, 1 hr, 1 hr 30 min, 2
hr, 2 hr 30 min, and each additional half hour up to nine hours.
3 To set the TIMER press the SET
button on the transmitter. If the
system is ON, it will remain on until the “timer” has expired. If the
system is in the THERMO mode, it will cancel ON and OFF as the
room temperature requires until the “timer time” has expired.
4 To cancel the TIMER operation, press the TIME/RTIME
button for
more than 2 seconds.
OPERATIONAL NOTE:
When the TIMER is used in the THERMO mode, the THERMO operation will discontinue only when the “countdown
time” has expired.
TEMP
SET
WE
THERMO
HOLD
ON
FLAME
TIMER
1
2
3
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
TEMP
SET
MO
DAY
PROGRAM
OVERRIDE
ON
FLAME
2
1
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
TEMP
SET
MO
DAY
PROGRAM
HOLD
ON
FLAME
3
1,2
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
TIME
TU
THERMO
ON
FLAME
PM
2
1
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK