Installation Guide

REV 3/17/05 Page 4 of 14
4 To program
the START TIME, press the UP or DOWN button.
Programmed start time settings are in 15 minute segments. The new set
time will display on the LCD screen.
5 When the desired START TIME displays, press the PROG
button and the
SET TEMPERATURE will flash on the LCD screen.
6 To program
the SET TEMPERATURE, press the UP or DOWN button.
7 When the desired SET TEMPERATURE displays, then press the PROG
button.
8 After pressing the PROG
button in step 7, the next PERIOD of the same or
next day will display on the LCD screen.
9 To program
the next PERIOD follow steps 3, 4, 5, 6 and 7.
10 Continue to follow steps 3, 4, 5, 6 and 7 until all 7 days and the 4 time
periods in each day are programmed.
11 Once ALL
the programming has been completed, then press the SET
button. The programming data that has been entered will now over-ride
the factory built-in program and operate your remote control system.
PROGRAMMING NOTE:
Once in the programming process and you want to advance the
programming procedure, you may bypass some of the DAYS or
PERIODS OF DAY, by pushing the AHEAD
or BACK buttons. This
allows you to eliminate the need to enter the TIME and
TEMPERATURE for each DAY/PERIOD speeding up the
programming process by skipping some of the ”software prompts”.
Once the LCD screen displays a DAY/PERIOD you want to
reprogram, press the PROG
button and follow the programming steps
outlined above.
PROGRAM REVIEW
If you want to review the settings for either the FACTORY program
and/or your CUSTOMIZED program, you may do so by pressing the
PROG
button for one second. To review other
settings, press the PROG
button allowing one
second between each press of the PROG
button. If
you press the PROG
button for 4 seconds, then you
go into the programming process. Press the SET
button
should you hold the PROG
button too long.
PROGRAM CANCELLATION
Should you want to cancel the CUSTOMIZED program that you have entered and return to the FACTORY program, you may do so. To cancel
a CUSTOMIZED program:
1. Press the SET
button to make sure the LCD screen is in normal state.
2. Then press and hold the PROG
button and, at the same time, press the SET button for a period of 10 seconds.
3. The customized programs will be cancelled when the display icons/numbers flash with some icons disappearing. The LCD screen will
begin flashing PROGRAM FOR, START AT, and the digits in the TIME and SET frames will begin flashing. This confirms CUSTOMIZED
programs have been cancelled.
4. Push the SET
button to return LCD screen to normal state or wait 10 seconds and LCD screen will return to normal state automatically.
TIME
SET
AM
START
AT
PROGRAM
FOR
SU
MORN
4
5
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
TIME
SET
AM
START
AT
PROGRAM
FOR
SU
MORN
6
7
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
TIME
SET
AM
START
AT
PROGRAM
FOR
SU
DAY
11
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
TIME
SET
AM
START
AT
PROGRAM
FOR
SU
MORN
1
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK