Installation Guide

REV 3/17/05 Page 3 of 14
SETTING THE CURRENT HOUR AND MINUTES
1. Following Step 3 on the previous page, the HOUR digits will begin flashing in the
TIME frame on the LCD screen.
2. To set the current HOUR, press the UP
or DOWN button setting the HOUR for the
corresponding AM/PM time period.
3. After setting the current HOUR, press the SET
button on the front of the transmitter,
and the MINUTE digits will begin flashing on the LCD screen.
4. To set the current MINUTES, press the UP
or DOWN button setting to the correct
MINUTES.
5. After setting the HOURS and MINUTES, press the SET
button on the front of the
transmitter.
The initial set-up/programming of the transmitter is now complete. Be sure the
slide-on battery cover is reinstalled and proceed to the next step. The LCD screen
will now display in its normal state.
PROGRAM OPERATION OF REMOTE CONTROL
BUILT –IN PROGRAM
The transmitter has a factory program built in. Each day has been broken into four periods and
each period has its own starting time and temperature. A chart of the built- in programs is at the
left.
You may change any of the factory settings by following the procedures below. Should you wish
to return to the factory program, follow the procedures under heading PROGRAM REVIEW or
PROGRAM CANCELLATION depending on which process you select.
PROGRAMMING DAYS/PERIOD OF DAY/SET TEMPERATURES
PROGRAMMING THE TRANSMITTER
The user may change the built-in time and temperature programs to suit their personal schedule. Each day is divided into four
periods: MORNING, DAY, EVENING, AND NIGHT. A blank programming chart is provided to the left to record your customized time and
temperature settings.
If desired, you may change a single day or all seven days that have the built-in factory program. To change one or all seven days,
complete the following steps:
1 Press the PROG button for 4 seconds. The shaded boxes on the LCD
screen with the words PROGRAM FOR
and START AT will begin to flash.
The current DAY, PERIOD, TIME and SET temperature of the BUILT-IN
FACTORY PROGRAM will also be displayed.
NOTE: If the above settings were not previously completed during the
initial SET-UP and PROGRAMMING procedure, then the LCD screen will
display SU, MORN, TIME and SET temperature digits. You must go back
and perform the intiial set-up procedure or the remote will not operate
properly in the PROGRAM mode. SEE PAGE 2.
2 To program
the DAY and PERIOD OF DAY, press the AHEAD or BACK
buttons to display the DAY and PERIOD you wish to program.
3 When the DAY and PERIOD being programmed displays, then press the
PROG
button and the TIME will flash on the LCD screen.
3
2
TIME
SU
AM
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
TIME
SET
AM
START
AT
PROGRAM
FOR
SU
MORN
1,3
2
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
PERIOD
DAY
MORN DAY
EVE NITE TIME/TEMP
SU
MO
TU
WE
TH
FR
SAT