Installation Guide

REV 3/17/05 Page 2 of 14
FUNCTIONS
To operate the system, press the MODE button on the transmitter to select the operational MODE
desired.
• ON indicates the system is on, either manually, timed, thermostatically, or program
• THERMO indicates the system will automatically cycle ON/OFF, depending on programmed
set temperature.
• OFF indicates the entire system is turned off.
• PROGRAM indicates the system will automatically cycle ON/OFF in the programmed mode
depending on the 7 day/4 period program that is in memory.
BUTTON SETTINGS
Flip open the plastic cover on the front of the transmitter to expose the “SET” buttons. The flip cover
protects the SET buttons from being changed accidentally. Close the cover after completing the following
settings/ programming.
Flashing numbers on the display indicate the system is awaiting user input, such as using the UP and
DOWN buttons to program a new setting. If no change is made to flashing digits within 15 seconds, the
system will complete the procedure last programmed and reset the display to its normal state.
INITIAL SET-UP PROGRAMMING OF TRANSMITTER
Follow the procedures below, upon FIRST USE of transmitter, setting the following program options:
• TEMPERATURE SETTING –
0
F (Fahrenheit) or
0
C (Celsius)
• CURRENT DAY OF WEEK – SU, MO, TU, WE, TH, FR, SA
• CURRENT TIME OF DAY –Hours and minutes
To program settings, first remove the battery cover on the back of the transmitter. If you have not already
installed the 2-AAA batteries, this would be a good time to do so. Note the small push button at the upper
left side of the battery compartment. This is the button used to perform the initial transmitter programming
.
You will need to use a paper clip or sharp end of a pencil to depress this button.
CHANGING THE TEMPERATURE SCALE
1. Press setting button on back of transmitter ONCE and the
0
F symbol will begin
flashing on the LCD screen. You may replace the battery cover at this time.
2. To change
0
F to
0
C, press the UP or DOWN button on the front of the
transmitter.
3. After setting/confirming the preferred temperature SCALE, press the SET
button on the front of the transmitter.
NOTE: You will need to press the SET
button, confirming
0
F, if you want the
temperature readings to be in
0
F.
SETTING THE CURRENT DAY OF THE WEEK
Following Step 3 above, the symbol SU will begin flashing on the LCD screen.
1 To change to the current day of the week Press the AHEAD
or BACK
button on the front of the transmitter.
2 After setting/confirming the current Day of the week, press the SET
button on the front of the transmitter.
NOTE:
You will need to press the SET button, confirming SU, if that is the
current day.
Setting
Button
SU
TEMP
ON OFF THERMO PROGRAM
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
3
2
TIME
SU
AM
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
3
2
TIME
SU
AM
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK