Installation Guide

REV 3/17/05 Page 14 of 14
QUICK PROGRAMMABLE GUIDE
FOR SKYTECH 3301P PROGRAMMABLE TRANSMITTER
This guide is a “short cut” method to PROGRAM the operation of the SKYTECH programmable transmitter.
For detailed instructions for each feature and function, see OWNER”S MANUAL.
PROGRAMMING DAILY OPERATION
NOTE: A FACTORY PROGRAM is already installed in the
transmitter’s software.
You may change the daily “SET TIMES” and “SET
TEMPERATURES” by
following the instructions below.
SHORT CUT PROGRAMMING
1. Press PROG button for more than 4 seconds. The PROGRAM FOR
an START AT boxes on the LCD will begin blinking.
2. Program DAY OF WEEK and PERIOD OF DAY by pressing AHEAD
and BACK buttons.
3. Again, press PROG button. START TIME will begin flashing.
4. Program START TIME by pressing UP or DOWN button.
5. Again, press PROG button. SET TIME will begin to flash.
6. Program SET TEMP by pressing UP or DOWN button.
7. Again, press PROG button. The next PERIOD and DAY will begin to
flash.
8. Repeat steps 2 through 7 for all 7 DAYS until each PERIOD OF DAY
is programmed.
9. When all programmed settings are complete, then press the SET to
lock in new programming.
10. To REVIEW, either FACTORY or USER programs, push the PROG
button for ONE SECOND; then scroll through each DAY and PERIOD
OF DAY by pressing PROG button, allowing ONE SECOND between
each press of this button. Press the SET button when through
reviewing the programmed times and temperatures.
11. To CANCEL user-customized programming, press and hold PROG
and SET buttons together, for 10 seconds; all USER programs will be
cancelled and the FACTORY program will return
NOTE: Push AHEAD or BACK buttons to advance day and period should you not want to change
each SET time or SET temperature.
DAY
PERIOD
TIME/TEMP
All 7 Days
MORN
6:00 AM 70
Factory-
Programmed
DAY
EVE
NIGHT
8:30 AM 60
3:00 PM 70
11:00 PM 63
9
1
TIME
SET
AM
START
AT
PROGRAM
FOR
SU
MORN
1
4
6
2
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK