Instruction Manual

REV. 2-18-22 Page 2

Skytech: 3002

BASIC TRANSMITTER FUNCTIONS

To understand the operation of the transmitter, press and release the MODE button (Fig. 3) until the LCD screen reads

OFF in the display (Fig. 4).

Step 1: Press the MODE button one time to manually turn ON the appliance (Fig. 5).

Step 2: Press the MODE button a second time to put the to put the system in THERMO mode (Fig. 6).

Step 3: Press the MODE button a third time to turn the appliance back OFF again as show in (Fig. 4).

Fig. 4 OFF Mode

ROOM

SET

Fig. 5 Manual ON

ROOM

SET

Fig. 6 Thermo Mode

ROOM

SET

Slide down the lower section of the cover on the front of the transmitter to expose the “SET” buttons (Fig. 1). The slide

cover protects the SET buttons from being changed accidentally. Close the cover after completing the following settings/

programming.

Blinking numbers on the LCD display indicate the system is awaiting user input, such as using the UP and DOWN buttons

to program a new setting. If no change is made to ashing digits within 15-seconds, the system will complete the

procedure last programmed and reset the display to its normal state.

SETTING UP THE TRANSMITTER

Fig. 3 Mode Button

MODE

1. BATTERY ICON - Symbol means battery power is low. Replace batteries within 2-weeks.

2. TIMER- Indicates time remaining before system shuts OFF, when timer-programmed; 9-hour maximum setting.

3. MODE- Indicates operation MODE of system. ON indicates the system is manually ON. OFF indicates the entire

system is turned OFF and THERMO indicates the system will automatically cycle ON/OFF, depending on the SET

temperature.

4. SET- Indicates desire SET room temperature for THERMO operation.

5. FLAME – Indicates burner/valve in ON position.

6. CLOCK – Indicates the current time in AM/PM

7. ROOM – Indicates CURRENT room temperature.

8. °F indicates degrees Fahrenheit (°C indicates degrees Celsius).

LCD DISPLAY FUNCTIONS

ROOM

SET

Fig. 2 LCD Display Functions