Installation Guide
Rev. 4/18/05 Page 2 of 7
SETTING
0
F /
0
C SCALE
The factory setting for temperature is
0
F. To change this setting to
0
C, first
• Press the ON
key and the OFF key on the transmitter at the same time this
will change from
0
F to
0
C. Follow this same procedure to change from
0
C back to
0
F.
MANUAL FUNCTION
To operate the system in the manual “MODE” does the following.
ON OPERATION
Press the ON
key the appliance flame will come on. During this time the LCD
screen will show ON, after 3 seconds the LCD screen will default to display
room temperature and the word TEMP will show. (Flame icon will appear on
LCD screen in on mode)
OFF OPERATION
Press the OFF
key the appliance flame will shut off. During this time the LCD
screen will show OF, after 3 seconds the LCD screen will default to display
room temperature and the word “TEMP” will also show on the screen.
THERMOSTAT FUNCTION
SETTING DESIRED ROOM TEMPERATURE
This remote control system can be thermostatically controlled when the
transmitter is in the THERMO mode (The word ROOM
must be displayed on
the screen). To set the THERMO MODE and DESIRED room temperature,
Press the MODE
key until the LCD screen shows the word ROOM, then the
remote is in the thermostatic mode.
Press and hold the SET
key until the desired set temperature is reached. (By
pressing and holding the set key the LCD screen set numbers will increase
from 45
0
to 99
0
then restart over at 45
0
) Next release the SET key. The LCD
screen will display the set temperature for 3 seconds and the LCD screen will
flash the set temperature for 3 seconds, then the LCD screen will default to
display the room temperature.
TO CHANGE THE SET TEMPERATURE
Press and hold the SET
key until the desired set temperature is reached. (By
pressing and holding the set key the LCD screen set numbers will increase
from 45
0
to 99
0
then restart over at 45
0
) Next release the SET key. The LCD
screen will display the set temperature for 3 seconds, then will flash the set
temperature for 3 seconds, then the LCD screen will default to display the room
temperature.
Press the MODE
key to disengage the thermo mode. The word ROOM on the
LCD screen will not show when the thermo is not in operation.
NOTE: The highest SET temperature is 99
0
Fahrenheit (32
0
Celsius) and the
lowest temperature is (45
0
Fahrenheit (6
0
Celsius)
TEMP
TEMPSET
THERMO SET
SCREEN WHILE
DEPRESSING OFF
KEY
TEMP
SCREEN AFTER 3
SECOND DEFAULT
ROOM
TEMP
THERMO
MODE
TEMP
SCREEN AFTER 3
SECOND DEFAULT
ROOM
TEMP
THERMO
ON
ROOM
TEMP
THERMO
OFF
SCREEN WHILE
DEPRESSING ON
KEY