Installation Guide

Rev. 4/18/05 Page 1 of 7
1001 TH
INSTALLATION AND OPERATING INSTRUCTIONS
INTRODUCTION
SKYTECH’S remote control system was developed to provide a safe, reliable and user-friendly remote control system for gas heating
appliances. This all battery system operates independently of household current. The system operates on radio frequencies with a non-
directional signals. The SYSTEM’s operating range is approximately 20 feet range. The system operates on one of 1,048,576 security codes
that are programmed into the transmitter at the factory; the remote receiver's code must be matched to that of the transmitter prior to initial use.
TRANSMITTER
This remote control SYSTEM offers the user a battery-operated remote control that
operates most millivolt gas valves used in some heater rated gas logs, gas fireplaces
and other gas heating appliances.
The transmitter operates on (2) 1.5V AAA batteries.
It is recommended that ALKALINE batteries always be used for longer battery life and
maximum operational performance.
Before using the transmitter, install the (2) AAA transmitter batteries into the battery
compartment. (Use caution that batteries are installed in the proper direction)
KEY SETINGS
ON - Operates unit to on position, Manually ON.
OFF - Operates unit to off position, Manually OFF.
MODE - Changes unit from manual mode to thermo mode.
SET - Sets temperature in thermo mode.
1. DISPLAY Indicates CURRENT room temperature .
2.
0
F OR
0
C Indicates degrees Fahrenheit or Celsius.
3. FLAME Indicates burner/valve in operation.
4. ROOM Indicates remote is in THERMO operation.
5. TEMP Appears during manual operation.
6. SET Appears during time the of setting the desired temperature in
the thermo operation.
ROOM
LCD - Liquid Crystal Display
TEMP
1
2
3
SET
4
5
6
ON
MODE
OFF
SET
1
2
3
4
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO NOT
ATTEMPT TO INSTALL OR OPERATE
ON
MODE
OFF
BUTTON
WALL CLIP
SLOT
BATTERY
COMPARTMENT
FRONT BACK
OFF
SET
ON
BUTTON
MODE
BUTTON
SET
BUTTON
Review COMMUNICATION SAFETY SECTION under TRANSMITTER section and THERMO SAFETY SECTION under REMOTE
RECEIVER section. These signal/temperature safety features shut down the fireplace system when a potentially unsafe condition exists.

Summary of content (7 pages)