User's Manual

REV 3/3/04
Page 1 of 5
TS/R-2
INSTALLATION AND OPERATING INSTRUCTIONS
INTRODUCTION
SKYTECH’S remote wall mount thermostat system was developed to provide a safe, reliable and user-friendly wireless remote wall mount
thermostat for gas heating appliances. Battery operation allows the system to operate independently of household current. The system
operates on radio frequencies with non-directional signals. The SYSTEMS operating range is approximately 20 feet. The system operates on
one of 255 security codes programmed at the factory.
COMPONENTS
THE SKYTECH TS/R-2 MUST BE INSTALLED EXACTLY
AS OUTLINED IN THESE INSTRUCTIONS. READ
COMPLETELY BEFORE ATTEMPTING INSTALLATION.
FOLLOW INSTRUCTIONS CAREFULLY DURING
INSTALLATION. ANY MODIFICATION OF THE
SKYTECH TS/R-2 OR ANY OF ITS COMPONENTS WILL
VOID THE WARRANTY AND MAY POSE A FIRE
HAZARD.
WALL MOUNT THERMOSTAT
The wall/transmitter operates on (2) 3V Button Cell (Included) which powers the LCD screen. These
batteries are made specifically for remote controls and electronic lighters. Before using the transmitter the
3V batteries must be installed into the battery compartments.
It is recommended that ALKALINE batteries always be used for longer battery life and maximum
operational performance.
Upon initial use, there may be a delay of five seconds before the remote receiver will respond to the
transmitter. This is part of the system’s design. If the LCD screen will not come on, check the 3V Button
Cell battery.
To activate LCD screen install the (2) 3V button cell batteries.
The wall thermostat operates on a (2) 3V button cell
batteries (included) made specifically for remote controls.
Before using the wall thermostat, install the two (2) 3V
button cell batteries. Follow instructions below.
First you must remove the face of the thermostat. This is
Done by sliding the face up about 1/2” then pull the face
off the base plate. As shown at the right.
TO INSTALL BATTERIES IN THE WIRELESS THERMOSTAT
1. Remove face from backing plate and locate the (2) holders for the 3V button cell batteries.
2. Slide the button cell batteries into the battery holders. (Make sure that the batteries
are installed with the (+) plus side facing you).
TO REMOVE THE BATTERIES IN THE WIRELESS THERMOSTAT
1. Remove face from backing plate and locate the (2) holders for the 3V button cell batteries.
2. Insert a small screwdriver into the slot above the button cell battery and push the battery out (Slots
shown in picture to the left).
ROOM
TEMP
ON
OFF
SET
ROOM
TEMP
THERMO
MODE
“SET”
ON
SET
OFF
LCD
DISPLAY
ON/UP
BUTTON
OFF/DOWN
BUTTON
SET
BUTTON
TOP
TRANSMITTER
REMOTE RECEIVER
SLIDE
BUTTONS
REMOTE
ON
OFF
SLIDE-ON COVERPLATE
R
E
M
O
T
E
ON
OFF
2 ea.
12V (A23) Transmitter
battery(included in
transmitter)
4 ea.
WALL-MOUNT COVERPLATE
HARDWARE
(2) 3V Button Cell Transmitter
batteries (included in
transmitter)
AA BATTERIES
3V
3V
ROOM
TEMP
ON
SET
OFF
SET
WIRING KIT
BACK OF UNIT
(2) 3 Volt Button
Cell Batteries
Battery Removal
Slots
+
Plus
Side
+
Plus
Side