User Manual

8
VI. Installation
Attach Trap Connector (contents part D) to foot pedal release cable
WARNING: MAKE SURE THAT THE THROWING ARM IS IN THE
UNCOCKED POSITION, THE TRAP IS IN THE OFF POSITION AND THE
TRAP IS DISCONNECTED FROM THE BATTERY.
MAKE SURE THE TRAP FUNCTIONS CORRECTLY USING THE FOOT
PEDAL AND ANY ADJUSTMENTS TO THE TRAP ARE MADE BEFORE
INSTALLING ANY REMOTE RELEASE SYSTEM.
- Cut foot pedal release cable about 2 to 3 feet from body of trap
- From the cable coming from the trap, remove 1-1/2” of outer insulation from cable and
1/2” of insulation from each of the 2 signal wires as shown
- Fold over 1/4” of the bare signal wires back as shown
- Using a small screwdriver first fully loosen each of the lock screws in the trap
connector. Insert each of the signal wires into the connector so there is 3/4” of insulated
signal wire left out of the connector as shown. Tighten each of the lock screws fully so
they grip each wire.
1/2”
1-1/2”
3/4”
Lock screws
To trap
Machin
e