User Manual

Front

G – T1

o Press T1 to select the desired time delay (in seconds) when release signal

sent to first receiver after release sequence is started

H - #T

o Press #T to select number of traps in use

J – SEQ

o Press SEQ to select trap release sequence.

A-B: If #T is 1 then release signal sent to receiver A.

If #T is 2 then release signal sent to A then B.

B-A: If #T is 1 then release signal sent to receiver B.

If #T is 2 then release signal sent to B then A.

A&B: If #T is 1 then this setting unavailable.

If #T is 2 then release signal sent to A&B.

Rnd: If #T is 1 then release signal randomly sent to

either A or B.

If #T is 2 then release signal randomly selects

A-B, B-A or A&B.

K – T2

o Press T2 to select the desired time delay (in

seconds) when release signal sent to second

receiver after release signal sent to first receiver

(disabled if SEQ set to A+B).

L - ARM

o Press ARM to select Manual or Auto release.

o Manual mode: Press RESET to start release sequence and send release signal

to receiver(s)

o Auto mode: when system is armed a voice/sound command will start release

sequence and send release signal to receiver(s)

M- RESET

o Manual mode: Press RESET to start release sequence and send release signal

to receiver(s)

o Auto mode: Press RESET to arm system. System now ready to accept

voice/sound command. Voice/sound command will start release sequence

and send release signal to receiver(s). Adjust microphone sensitivity dial if

receiver(s) do not activate. Press RESET again to disarm system.

(Once a voice/sound command is received, the microphone will be

deactivated for 4 seconds if #T is set to 1, and 6 seconds if #T is set to 2)

 LED display will illuminate when any setting button is pressed and automatically

turn off after 5 seconds to conserve battery power.

 All user settings are retained after the on/off microphone dial is turned off.

 Pushing any button while in auto mode will disarm unit.