User Manual

4
IV. Features and Descriptions
Receiver Unit
A - ARM Button:
o Press the ARM button to allow the receiver to accept transmitter commands
and enable receiver output (arm).
o Press the ARM button again to prevent the receiver from accepting
transmitter commands and disable the receiver output (disarm).
B - POWER LIGHT (Green):
o Illuminates continuously when receiver is connected to 12V power.
C - READY LIGHT (Red):
o Illuminates continuously when receiver is armed.
o Flashes when receiver is in “Learn” mode
D - REMOVABLE ANTENNA: Must be attached for proper operation
E - 12V POWER CONNECTIONS (Red and Black wires):
o Red wire clip connects to positive (+) terminal on 12V battery
o Black wire clip connects to negative (-) terminal on 12V battery
F - OUTPUT CONNECTOR (White wires and connector):
o Connects to foot pedal or hand release cable for trap
Inside Controls (remove bottom panel):
G - PROGRAMMING BUTTON:
o Press button to enter LEARN mode. The LEARN mode will automatically
cancel after 30 seconds if no transmission is received.
H - ACTIVATION ADJUSTMENT DIAL:
o Adjust for how long output relay will be activated (.5 to 3 sec)
A
B
D
E
F
C
H
G