User Manual

IX. Troubleshooting

WARNING: MAKE SURE THAT THE THROWING ARM IS IN THE

UNCOCKED POSITION, THE TRAP IS IN THE OFF POSITION AND THE

TRAP IS DISCONNECTED FROM THE BATTERY BEFORE MAKING

ANY ADJUSTMENTS TO RECEIVER OR TRAP.

The Trap Arm Rotates But Doesn’t Launch a Target

1. Rotate the adjustment dial located inside the receiver clockwise to a

larger number (see Page 11)

The Trap Launches More Than 1 Target

1. Rotate the adjustment dial located inside the receiver counter clockwise

to a smaller number (see Page 11)

The Transmitter Power Light is Rapidly Flashing

1. Replace the batteries in the transmitter

The Transmitter Does not Operate the Trap

1. Check that the red READY light on the receiver is on

2. Check that the armed light on the transmitter turns on when the reset

button is pushed in manual mode, or a sound command is received in

auto mode

3. Reprogram the receiver to the push button transmitter (see Section V)

4. Replace the batteries in the transmitter and check battery orientation

5. Check that the receiver is receiving a signal from the transmitter

- With the trap turned OFF, listen that the receive clicks when the

transmitter sends a signal.

6. Check the wiring from the receiver to the trap machine

Reduced Operating Range

1. Replace the batteries in the transmitter

2. Reposition the receiver unit