User Manual

VII. Operation

To operate trap(s) follow the steps below:

1. Safe release trap, set trap main power switch to OFF and disconnect trap from 12V

battery

2. Plug receiver output connector into trap connector on release cable of trap

3. Connect trap to 12V battery

4. Connect receiver to 12V battery. Red clip connects to positive (+), Black clip connects

to negative (-). If the battery terminals are too big to connect the clips to, connect the

receiver power clips to the trap power clips (Green POWER light turns on)

5. Set trap main power switch to ON or RUN

6. Press ARM button on receiver (Red READY light turns on), Repeat for second trap if

needed.

7. Turn the remote transmitter ON/OFF MICROPHONE dial to the midpoint position

between MIN and MAX to set the initial microphone sensitivity.

8. Program trap release sequence using buttons on front of transmitter. See Pages 6, 12

and 13. In bright sunlight, shield the transmitter from the sun so the LED's can be seen

easier.

When the transmitter is set to AUTO mode:

- The microphone sensitivity will need to be adjusted so a loud voice call (PULL!,

BIRD!, etc) will activate the transmitter, but background noise and loading/re-

loading a shotgun will not activate the transmitter. Turn microphone dial clockwise

to increase sensitivity (softer sound will activate the transmitter) or

counterclockwise to decrease sensitivity (louder sound will activate the transmitter).

- In certain situations it may work best to disarm transmitter immediately after

shooting a target, and then rearming it when ready to shoot again.

- In windy conditions stretch the foam microphone

wind filter over the microphone to reduce the

sensitivity of the microphone to wind noise. The

filter can be permanently attached with a small

drop of adhesive.