User's Manual

MODE Zone) will flash 3-times (0.5-seconds OFF, 0.5-seconds ON) to indicate the
change has been made.
Fan Adjustment
Transmits a fan setting command to the control module to adjust the fan output level.
Available settings are 0 (off) – 3 with a factory default setting of 2. If the user changes
the fan speed during operation, the control will remember and use the adjusted setting on
subsequent fan ON cycles (fan speed memory).
While in Manual ON, THERMOSTAT ON, or PROGRAM ON modes, press the FAN
Zone to enter Fan Adjustment, then press the UP or DOWN buttons to increase or
decrease the fan output; press the MODE/SET Button or wait for 15 seconds to accept the
new setting.
LCD Displays:
o When raising or lowering the fan output level with the UP or DOWN buttons, the
fan icon and fan setting number will flash in the FAN Zone.
Fan Adjustment Disable Feature
The Fan Adjustment Feature (described above) may be enabled for applications where an
auxiliary module and electric fan is used.
THE FACTORY DEFAULT IS DISABLED. When the Fan Adjustment Feature is
Disabled:
o The FAN icon and setting number will not be displayed.
o No adjustment to the Fan setting can be made.
o The FAN output will not be energized.
To disable or re-enable the Fan Adjustment Feature, the transmitter must be in MANUAL
OFF Mode, then press and hold the FAN Zone and the DOWN Button simultaneously for
10-seconds. The LCD screen will go blank except either the FAN Icon and OFF (OFF
display in MODE Zone) or the FAN Icon and ON (ON display in MODE Zone) will flash
3-times (0.5-seconds OFF, 0.5-seconds ON) to indicate the change has been made.
AUX (or Cracker) Adjustment
Transmits an AUX setting command to the control module to turn the AUX output ON or
OFF.
While in any mode of operation, press the AUX Zone to enter AUX Adjustment, then
press the UP or DOWN buttons to turn the AUX output ON or OFF; press the
MODE/SET Button or wait for 15 seconds to accept the new setting.
LCD Display:
o When adjusting the AUX output, AUX and AUX setting (ON or OFF) will flash
in the AUX Zone.
AUX (or Cracker) Adjustment Disable Feature
The AUX Adjustment Feature (described above) may be enabled for applications where
an auxiliary module and suitable electronics output are used.
THE FACTORY DEFAULT IS DISABLED. When the AUX Adjustment Feature is
Disabled:
o AUX and the setting will not be displayed.
o No adjustment to the AUX setting can be made.
o The AUX output may not be energized.
To disable or re-enable the AUX Adjustment Feature, the transmitter must be in
MANUAL OFF Mode, then press and hold the AUX Zone and the DOWN Button