Specifications

display in MODE Zone) or the FAN Icon and ON (ON display in MODE Zone) will flash
3-times (0.5-seconds OFF, 0.5-seconds ON) to indicate the change has been made.
Light Adjustment
• Transmits a light setting command to the control module to adjust the light output level.
• Available settings are 0 (off) – 6 with a factory default of 0 (off).
• While in any mode of operation, press the LIGHT Zone to enter Light Adjustment, then
press the UP or DOWN buttons to raise or lower the light output; press the MODE/SET
Button or wait for 15 seconds to accept the new setting.
• LCD Displays:
o When raising or lowering the light output level with the UP or DOWN buttons,
the light icon and light setting number will flash in the LIGHT Zone.
Light Adjustment Disable Feature
• The Light Adjustment Feature (described above) may be disabled for applications where
electrical lighting is not used. When the Light Adjustment Feature is Disabled:
o The LIGHT icon and setting number will not be displayed.
o No adjustment to the Light setting can be made.
o The LIGHT output may not be energized.
• To disable or re-enable the Light Adjustment Feature, the transmitter must be in
MANUAL OFF Mode, then press and hold the LIGHT Zone and the DOWN Button
simultaneously for 10-seconds. The LCD screen will go blank except either the LIGHT
Icon and OFF (OFF display in MODE Zone) or the LIGHT Icon and ON (ON display in
MODE Zone) will flash 3-times (0.5-seconds OFF, 0.5-seconds ON) to indicate the
change has been made.
AUX Adjustment
• Transmits an AUX setting command to the control module to turn the AUX output ON or
OFF.
• While in any mode of operation, press the AUX Zone to enter AUX Adjustment, then
press the UP or DOWN buttons to turn the AUX output ON or OFF; press the
MODE/SET Button or wait for 15 seconds to accept the new setting.
• LCD Display:
o When adjusting the AUX output, AUX and AUX setting (ON or OFF) will flash
in the AUX Zone.
AUX Adjustment Disable Feature
• The AUX Adjustment Feature (described above) may be disabled for applications where
an AUX output is not used. When the AUX Adjustment Feature is Disabled:
o AUX and the setting will not be displayed.
o No adjustment to the AUX setting can be made.
o The AUX output may not be energized.
• To disable or re-enable the AUX Adjustment Feature, the transmitter must be in
MANUAL OFF Mode, then press and hold the AUX Zone and the DOWN Button
simultaneously for 10-seconds. The LCD screen will go blank except either AUX and
OFF (OFF display in MODE Zone) or AUX and ON (ON display in MODE Zone) will
flash 3-times (0.5-seconds OFF, 0.5-seconds ON) to indicate the change has been made.