Specifications

Continuous Pilot Operation
• To activate or deactivate the Continuous Pilot Feature, press and hold the MODE/SET
and UP Buttons simultaneously for 5 seconds.
• LCD Display: When activated, CONT. PILOT will flash for 15-seconds, then CONT.
PILOT be displayed continuously in the MODE Zone.
Child-Lock Operation
• Child-Lock operation prevents any user input to the transmitter. No mode of operation or
feature may be adjusted when Child-Lock is activated. All automatic functions
(thermostat, program, etc.) will continue normally.
• To activate or deactivate the Child-Lock feature, press and hold the MODE/SET and
DOWN Buttons simultaneously for 5 seconds.
• LCD Displays:
o When activated, the LOCK icon will appear in the MODE Zone.
o If any touch-zone or button is pressed when activated, the LCD backlight will
illuminate and the LOCK icon will flash for 5 seconds in the MODE Zone.
Communication Safety
• In manual ON, thermostat and program modes of operation, the transmitter will send a
communication safety transmission every 15-minutes. This signal is further processed by
the ignition control module to verify the transmitter is communicating properly.
FCC REQUIREMENTS
This Transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.