User's Manual

AUX Adjustment
• Transmits an AUX setting command to the control module to turn the AUX output ON or
OFF.
• While in any mode of operation, press the AUX Zone to enter AUX Adjustment, then
press the UP or DOWN buttons to turn the AUX output ON or OFF; press the
MODE/SET Button or wait for 15 seconds to accept the new setting.
• LCD Display:
o When adjusting the AUX output, AUX and AUX setting (ON or OFF) will flash
in the AUX Zone.
AUX Adjustment Disable Feature
• The AUX Adjustment Feature (described above) may be disabled for applications where
an AUX output is not used. When the AUX Adjustment Feature is Disabled:
o AUX and the setting will not be displayed.
o No adjustment to the AUX setting can be made.
o The AUX output may not be energized.
• To disable or re-enable the AUX Adjustment Feature, the transmitter must be in
MANUAL OFF Mode, then press and hold the AUX Zone and the DOWN Button
simultaneously for 10-seconds. The LCD screen will go blank except either AUX and
OFF (OFF display in MODE Zone) or AUX and ON (ON display in MODE Zone) will
flash 3-times (0.5-seconds OFF, 0.5-seconds ON) to indicate the change has been made.
Continuous Pilot Operation
• To activate or deactivate the Continuous Pilot Feature, press and hold the MODE/SET
and UP Buttons simultaneously for 5 seconds.
• LCD Display: When activated, CONT. PILOT will flash for 15-seconds, then CONT.
PILOT be displayed continuously in the MODE Zone.
Child-Lock Operation
• Child-Lock operation prevents any user input to the transmitter. No mode of operation or
feature may be adjusted when Child-Lock is activated. All automatic functions
(thermostat, program, etc.) will continue normally.
• To activate or deactivate the Child-Lock feature, press and hold the MODE/SET and
DOWN Buttons simultaneously for 5 seconds.
• LCD Displays:
o When activated, the LOCK icon will appear in the MODE Zone.
o If any touch-zone or button is pressed when activated, the LCD backlight will
illuminate and the LOCK icon will flash for 5 seconds in the MODE Zone.
Communication Safety
• In manual ON, thermostat and program modes of operation, the transmitter will send a
communication safety transmission every 15-minutes. This signal is further processed by
the ignition control module to verify the transmitter is communicating properly.