User's Manual

Fan Adjustment
• Transmits a fan setting command to the control module to adjust the fan output level.
• Available settings are 0 (off) – 6 with a factory default setting of 3. If the user changes
the fan speed during operation, the control will remember and use the adjusted setting on
subsequent fan ON cycles (fan speed memory).
• While in Manual ON, THERMOSTAT ON, or PROGRAM ON modes, press the FAN
Zone to enter Fan Adjustment, then press the UP or DOWN buttons to increase or
decrease the fan output; press the MODE/SET Button or wait for 15 seconds to accept the
new setting.
• LCD Displays:
o When raising or lowering the fan output level with the UP or DOWN buttons, the
fan icon and fan setting number will flash in the FAN Zone.
Fan Adjustment Disable Feature
• The Fan Adjustment Feature (described above) may be disabled for applications where a
fan is not used. When the Fan Adjustment Feature is Disabled:
o The FAN icon and setting number will not be displayed.
o No adjustment to the Fan setting can be made.
o The FAN output will not be energized.
• To disable or re-enable the Fan Adjustment Feature, the transmitter must be in MANUAL
OFF Mode, then press and hold the FAN Zone and the DOWN Button simultaneously for
10-seconds. The LCD screen will go blank except either the FAN Icon and OFF (OFF
display in MODE Zone) or the FAN Icon and ON (ON display in MODE Zone) will flash
3-times (0.5-seconds OFF, 0.5-seconds ON) to indicate the change has been made.
Light Adjustment
• Transmits a light setting command to the control module to adjust the light output level.
• Available settings are 0 (off) – 6 with a factory default of 0 (off).
• While in any mode of operation, press the LIGHT Zone to enter Light Adjustment, then
press the UP or DOWN buttons to raise or lower the light output; press the MODE/SET
Button or wait for 15 seconds to accept the new setting.
• LCD Displays:
o When raising or lowering the light output level with the UP or DOWN buttons,
the light icon and light setting number will flash in the LIGHT Zone.
Light Adjustment Disable Feature
• The Light Adjustment Feature (described above) may be disabled for applications where
electrical lighting is not used. When the Light Adjustment Feature is Disabled:
o The LIGHT icon and setting number will not be displayed.
o No adjustment to the Light setting can be made.
o The LIGHT output may not be energized.
• To disable or re-enable the Light Adjustment Feature, the transmitter must be in
MANUAL OFF Mode, then press and hold the LIGHT Zone and the DOWN Button
simultaneously for 10-seconds. The LCD screen will go blank except either the LIGHT
Icon and OFF (OFF display in MODE Zone) or the LIGHT Icon and ON (ON display in
MODE Zone) will flash 3-times (0.5-seconds OFF, 0.5-seconds ON) to indicate the
change has been made.