User's Manual

AF-4000HATPE

This AF-4000HATPE can communicate with the AF-4000MODPE control module providing

ON/OFF capability.

z Transmitter to be powered with 4 AA batteries for extended battery life.

Before using the transmitter，install the (4) AA batteries into the battery compartment. (Use caution that batteries

are installed in the proper direction).

MANUAL FUNCTION

OFF/AUTO Switch

 When the switch is set to AUTO, the transmitter will be set to receive dry contact

signals from a home automation system.

 When the switch is switched to OFF, the transmitter will send a manual OFF signal and

will not react to dry contact signals from the home automation system.

 The transmission signals must be the same coding as the manual ON and OFF

signals transmitted by AF-4000PEHH.

PAGE 1
AF-4000HATPE This AF-4000HATPE can communicate with the AF-4000MODPE control module providing ON/OFF capability. z Transmitter to be powered with 4 AA batteries for extended battery life. Before using the transmitter，install the (4) AA batteries into the battery compartment. (Use caution that batteries are installed in the proper direction). MANUAL FUNCTION OFF/AUTO Switch When the switch is set to AUTO, the transmitter will be set to receive dry contact signals from a home automation system.
PAGE 2
Automated ON/OFF Operation When the OFF/AUTO switch is set to AUTO, the transmitter should monitor the status of the input wires that will be connected to a dry contact output from a home automation system. The control should respond to continuity state changes of the input per the following: When the state of the contacts change from open to closed (continuity sensed) the transmitter will send a single manual ON signal.