User's Manual

Draft
. Program mode:
A short push of (PROGRAM) button will select/operate the
PROGRAM mode. A long push (push & hold for more than 5 seconds)
of button will enter into the Setting of PROGRAM mode.
Following are the Factory setting for the PROGRAM mode:
MTWTF Segment 1(P1) On - 7:00am Off 8:00am
Segment 2(P2) On 5:00pm Off 7:00pm
S S Segment 1(P1) On 9:00am Off 10:00am
Segment 2(P2) On 6:00pm Off 9:00pm
Push & hold button for more than 2 seconds to enter the
setting for program mode:
& & on LCD
will flash, then you can use
or to change
the setting of “P1 ON＂. Then you push OK ( )
button to enter into next setting.
& & on LCD will
flash, then you can use or to change the
setting of “P1 OFF＂. Then, push OK button to enter into