User's Manual

Draft
.Thermo mode:
Selection of (THERMO) button will light the temperature
ICON and will light the smaller set of numbers ( )
The SET area should flash to 5 seconds and during this period of time the UP and Down
arrows will operated the Set Temperature to the correct setting. Once the correct
temperature is obtained, the temperature will continue to flash for 5 seconds and then it
will stop flashing (This means the SET process is completed.) The user will not have to
operate the “OK＂ button to set the temperature. But if the OK button is pushed, it
also completes the process for setting temperature.
You can use (DOWN) or (UP) buttons to
obtain the desired temperature. Then you can either let the
set area flash for 5 seconds or push the OK button to complete this process.
We should be able to operate the UP and DOWN arrows will direct the motor drive ONLY
after the 5 seconds of flashing.
On the backside of the TX, there is an unmarked recessed button,
you can completely turn off the THERMOSTATIC function of this
remote by pushing this recessed button.
This recessed button has sequence of events to turn on & off
The THERMOSTATIC function.
The “THERMOSTAT NOT＂ icon on the LCD screen will
appear for 5 seoncs only when the THERMOSTATIC function
is completed turned off.
This “THERMOSTAT NOT icon will light for 5 seoncs if the
THERMO button on the front of the TX is pushed.
In another words, this “THERMOSTAT NOT＂ icon will
NOT appear all the time.