User's Manual

Draft
.Timer function: Once this is selected, the timer ( ) icon will be on the screen and the
clock will flash “30＂minutes as the start point. But the users still can go down to
10 minutes and up to 180 minutes. The 10-minute segments remains unchanged.
By pushing (TIMER) button, You can set TIMER or cancel
TIMER function.
You use (DOWN) or (UP) button to set your
desired TIMER.
9 The range of TIMER is from 10 minutes to three hours or 180
minutes, in 10 minute segments.
9 IMPORTANT:Once the timing range is set, the user MUST
push (OK) button to activate the Timer. IF THE
“OK＂BUTTON IS NOT PUSHED, THE ORIGINAL FUNCTION
WILL CONTINUE TO OPERATE. In another words, Pacific Energy
would like to have the user too push the OK button to change the function.
The clock will start the countdown right after the completion of the
TIMER setting. At this time, if the
(TIMER) button is
pushed again, the TIMER function will be canceled. You＇ll have
to push the TIMER button again if you want to use the TIMER
function again.