User's Manual

Draft
The FLAME icon will be ON all the time the flame in the fireplace is ON, whether
it is under Manual ON, TIMER, THERMOSTAT or PROGRAM modes.
The UP arrow will appear on the LCD when the motor drive is to be moving into
the higher flame picture. Once the activation of the flame height is stopped, the
UP icon on the LCD will disappear.
The DOWN arrow will appear on the LCD when the motor drive is to be moving into
the Lower flame picture. Once the activation of the flame height is stopped, the
DOWN icon on the LCD will disappear.
Operation Matrix
Initial Set up: Push AUX 1 & AUX 2 buttons together for more than 5
seconds to start the process.
9
C/F conversion: Use UP or DOWN key to choose Celsius or
Fahrenheit, then press OK to enter “TIME”.
Setting.
Use UP or DOWN key to set HOUR, then press OK to
enter “Minute” setting.
Use UP or DOWN key to set “Minute”, then press OK
To enter AM/PM setting.
Use UP or DOWN key to set AM/PM, the press OK to
Enter “DAY” setting.
Use UP or DOWN keys to set correct DAY, then press OK to
finish the initial set up.
The users must use OK button to confirm and enter into next setting.
The icons will keep on flashing even though no button is pushed for more
5 seconds. H’ever, if no buttons is pushed for more than 2 minutes,
the system will automatically confirm the completion of the process and
the LCD will go back to Normal readouts.
Temperature swing: . This is factory set and can not be changed at all.