Installation and Operating Instructions

Model: 4001TH-A TX
REV. 3-31-20 Page 2
SETTING ºF / ºC
• The factory setting for temperature is ºF. To change this setting to ºC, press
the ON key and the OFF key on the transmitter at the same time. Follow
this same procedure to change from ºC back to ºF.
MANUAL FUNCTION
To operate the system manually perform the following:
ON OPERATION
Press the ON key the appliance ame will come ON. The Flame icon will
appear on LCD screen in ON mode
OFF OPERATION
Press the OFF key the appliance ame will shut OFF. The Flame icon will not
appear on LCD screen in OFF mode
THERMOSTAT FUNCTION
SETTING DESIRED ROOM TEMPERATURE
This remote control system can be thermostatically controlled when the
transmitter is in the THERMO mode (The word THERMO must be displayed
on the screen). To set the THERMO MODE and DESIRED room temperature,
press the SET button and the word THERMO will appear on the LCD screen;
remote is now in the thermostatic mode.
TO CHANGE SET TEMPERATURE
Press and hold the SET button until the desired set temperature is reached.
(By pressing and holding the SET button the LCD screen numbers will increase
from 45º to 99º then restart over at 45º again ) Next release the SET button.
The LCD screen will display the set temperature for 3 seconds and the LCD
screen will ash the set temperature for 3 seconds, then the LCD screen will
default to display the room temperature:
NOTE: The highest SET temperature is 99º Fahrenheit (37º Celsius) and the
lowest temperature is 45º Fahrenheit (7º Celsius).
When THERMO is operating in the ON position, the LCD screen will read
THERMO at the bottom with the ame icon. See THERMO-ON drawing.
When THERMO is OFF, the ame icon will not be displayed.
See THERMO-OFF drawing.
Press and release the OFF button to disengage the thermo mode. The word
THERMO on the LCD screen will not show when the thermo is not in operation.
THERMO
THERMO-ON
THERMO
THERMO-OFF
THERMO
THERMO-SET