Installation and Operating Instructions

Skytech: 3301
REV. 2-18-22 Page 2
Fig. 3 Mode Button
BASIC TRANSMITTER FUNCTIONS
To operate the transmitter, press and release the MODE button (Fig. 3) until the LCD screen reads OFF in the display
(Fig. 4).
Step 1: Press the MODE button one time to manually turn ON the appliance (Fig. 5).
Step 2: Press the MODE button a second time to put the to put the system in THERMO mode (Fig. 6).
Step 3: Press the MODE button a third time to turn the appliance back OFF again as show in Fig. 4.
Fig. 4 OFF Mode
ROOM
SET
Fig. 5 Manual ON
ROOM
SET
Fig. 6 Thermo Mode
ROOM
SET
Flip down the plastic cover on the front of the transmitter to expose the “SET” buttons (Fig. 1). The ip cover protects the
SET buttons from being changed accidentally. Close the cover after completing the following settings/programming.
Blinking numbers on the LCD display indicate the system is awaiting user input, such as using the UP and DOWN buttons
to program a new setting. If no change is made to ashing digits within 15-seconds, the system will complete the proce-
dure last programmed and reset the display to its normal state.
SETTING UP THE TRANSMITTER
DOWN
UP
MODE
SET
TIME
TIMER
COVER OPEN
The factory setting for temperature is ºF. To change this setting to ºC, rst press and hold
the UP and DOWN buttons on the transmitter at the same time. Follow this same procedure
to change from ºC back to ºF. When changing between the ºF and ºC scales, the
temperature in the SET frame defaults to the lowest temperature (45º F, or 6º C). The
highest SET temperature is 99º Fahrenheit (32º Celsius).
SETTING ºF / ºC SCALE
DOWN
UP
MODE
SET
TIME
TIMER
COVER OPEN
Fig. 7 Temperature Scale
1. BATTERY ICON - Symbol means battery power is low. Replace batteries within 2-weeks.
2. TIMER- Indicates time remaining before system shuts OFF, when timer-programmed; 9-hour maximum setting.
3. MODE- Indicates operation MODE of system. ON indicates the system is manually ON. When screens displays OFF
the entire system is turned OFF and THERMO indicates the system will automatically cycle ON/OFF, depending on
SET temperature.
4. SET- Indicates desire SET room temperature for THERMO operation.
5. FLAME – Indicates burner/valve are in the ON position .
6. CLOCK – Indicates the current time in AM/PM
7. ROOM – Indicates CURRENT room temperature.
8. °F indicates degrees Fahrenheit (°C indicates degrees Celsius).
LCD DISPLAY FUNCTIONS
ROOM
SET
1
2
3
4
5
6
7
8
Fig. 2 LCD Display Functions