User's Manual

temperature reading the TEMPERATURE will reappear in 15 seconds.
2. press the SET button to cancel the display of the time.
SETTING THE COUNTDOWN TIMER
This remote control can operate with a built-in, countdown timer when the transmitter is in the
ON or THERMO mode (THERMO or ON must be displayed on the LCD screen). DOES NOT
operate in PROGRAM MODE as times are pre-programmed into the transmitter.
1. Press the TIMER/TIME button on the transmitter for more than 2 seconds. The word TIMER
and 0:15 flash on the LCD screen.
2. Press the UP or DOWN button on the transmitter to begin advancing through each of the
countdown time options. Available countdown times are 15 min., 30 min, 45 min, 1 hr, 1 hr 30
min, 2 hr, 2 hr 30 min, and each additional half hour up to nine hours.
3. To set the TIMER press the SET button on the transmitter. If the system is ON, it will remain
on until the “timer time” has expired. If the system is in the THERMO mode, it will turn ON and
OFF as the room temperature requires until the “timer time” has expired.
4. To cancel the TIMER operation, press the TIMER/TIME button for more than 2 seconds.
OPERATING A FAN - (Operates only in ON/THERMO/PROGRAM MODES)
This remote control system has the capability of controlling the ON/OFF operation of a 110
VAC fan or blower system that may be included with your gas appliance. It only operates the
ON/OFF function for the fan/blower and cannot adjust a variable speed controller. When
properly connected to the remote receiver, the fan will only go ON or OFF by remote. You will
still be able to vary the speed of the fan/blower at the appliance, but not remotely with the
transmitter.
1. To turn the fan ON, press the Fan button on the transmitter. When the fan is operating, the
fan blade will display. Press the FAN button to turn fan OFF. When the fan is off, OFF will
display on the LCD screen below the word FAN.
2. When the transmitter is in the THERMO or PROGRAM modes and the FAN button is
pressed to ON, the FAN will operate ON and OFF as the cycling of the THERMO or
PROGRAM occurs. IF the FAN is in the OFF position, the fan will not operate until activated by
the FAN button.
ADJUSTING THE FLAME HEIGHT
1. HI/LO SOLENOID – Allows the user to change the flame height from LO to HI with a single
press of the FLAME button. The word HI and a second flame icon appears on the LCD screen
when HI flame is operated.
OPERATING THE HI/LO SOLENOID
To operate the HI/LO control, from the transmitter, ON/THERMO ON or PROGRAM ON must
be displayed on the LCD screen. NOTE User must have FLAME CONTROLLER set to HI/LO.
Review the procedure SETTING THE FLAME CONTROLLER under INITIAL SET-UP
PROGRAMMING OF TRANSMITTER in earlier section.
1. Press the FLAME button on the transmitter to change flame height from LO to HI. You will
note the word HI and a 2nd FLAME icon will appear on the LCD screen. Press again to change
from HI to LO.
LOW/BATTERY INDICATOR
The word LOW outlined by a battery on the left side of the LCD screen will appear when
battery power has dropped significantly. At this time, approximately two weeks of battery