User's Manual

icons disappearing. The LCD screen will begin flashing ROGRAM FOR, START AT, and the
digits in the TIME and SET frames will begin flashing. This confirms CUSTOMIZED
programs have been cancelled.
4. Push the SET button to return LCD screen to normal state or wait 10 seconds and LCD
screen will return to normal state automatically.
SWING (TEMPERATURE DIFERENTIAL)
1. To change the temperature “SWING” setting (1-3), press the AHEAD + BACK buttons
simultaneously to display the current “SWING” setting in the SET TEMP frame. The word
SWING will display on the LCD screen.
2. Press the UP or DOWN button to change the temperature differential or “SWING” (1-3). See
above for 1-3 “SWING” temperature values.
3. To store the “swing number”, press the SET button or allow 15 seconds to lapse, and the
new “swing number” will be automatically programmed.
SETTING DESIRED ROOM TEMPERATURE
This remote control system can be thermostatically controlled when the transmitter is in the
THERMO mode (THERMO must be displayed on the
screen).
1. To set the DESIRED room temperature, press the MODE button to place the transmitter into
THERMO mode. THERMO ON or OFF will display.
2. Then press the UP or DOWN button to select the DESIRED room temperature. The highest
SET temperature is 990 F (320 C). The lowest SET temperature is 450 F (60 C).
3. The TRANSMITTER will “sense” the room temperature every two minutes automatically
turning the fireplace ON or OFF thermostatically.
TEMPERATURE OVERRIDE – (Operates only in PROGRAM mode) The user may change
the current SET temperature without changing the programs stored in the transmitter’s
memory. The OVERRIDE feature will be automatically cancelled at the start of the next
PROGRAM PERIOD.
1. To change current SET TEMP, press the UP or DOWN key. (Setting will be cancelled
automatically when next program period begins.) The word OVERRIDE will appear over the
SET frame on the LCD.
2. To cancel temperature OVERRIDE, press SET button.
TEMPERATURE HOLD – (Operates only in PROGRAM mode.)
The user may override the SET temperature during any period, adjusting the SET temperature
to a CONSTANT new SET/HOLD temperature.
1. Press the UP or DOWN button to change the SET temperature to the level desired. The
word OVERRIDE will appear in SET frame on the LCD.
2. To HOLD the new temperature at a CONSTANT setting, push the UP and DOWN buttons
TOGETHER to activate the HOLD function. The word HOLD will appear over the SET frame
and the word OVERRIDE will disappear.
3. To cancel OVERRIDE or HOLD, press the SET button or HOLD will last until the next
programmed period change.
TIME OF DAY DISPLAY
1. To check the current TIME of day, press the TIMER/TIME button on the transmitter for less
than 1 second. The current TIME of day will appear in the TIME/TEMP frame replacing the