User's Manual

corresponding AM/PM time period.
3. After setting the current HOUR, press the SET button on the front of the transmitter, and the
MINUTE digits will begin flashing on the LCD screen
4. To set the current MINUTES, press the UP or DOWN button setting the correct MINUTES.
5. After setting the HOURS and MINUTES, press the SET button on the front of the transmitter
SETTING THE FLAME CONTROLLER
1. Following step 5 above, two flames, words HI FLAME will begin flashing on the LCD screen.
2. On this 3324R system press SET this will set the flame controller to HI/LO operation.
3. You can push the UP or DOWN button setting HI/LO or MODULATION on the LCD screen.
4. NOTE: The 3324R solenoid will only work when the flame controller is set to HI/LO.
PROGRAMMING THE TRANSMITTER
1. Press the PROG button for 4 seconds. The shaded boxes on the LCD screen with the words
PROGRAM FOR and START AT will begin to flash. The current DAY, PERIOD, TIME and
SET temperature of the BUILT-IN FACTORY PROGRAM will also be displayed.
2. To program the DAY and PERIOD OF DAY, press the AHEAD or BACK buttons to display
the DAY and PERIOD you wish to program.
3. When the DAY and PERIOD being programmed displays, then press the PROG button and
the TIME will flash on the LCD screen.
4. To program the START TIME, press the UP or DOWN button. Programmed start time
settings are in 15 minute segments. The new set time will display on the LCD screen.
5. When the desired START TIME displays, press the PROG button and the SET
TEMPERATURE will flash on the LCD screen.
6. To program the SET TEMPERATURE, press the UP or DOWN button.
7. When the desired SET TEMPERATURE displays, then press the PROG button.
8. After pressing the PROG button in step 7, the next PERIOD of the same or next day will
display on the LCD screen.
9. To program the next PERIOD follow steps 3, 4, 5, 6 and 7.
10. Continue to follow steps 3, 4, 5, 6 and 7 until all 7 days and the 4 time periods in each day
are programmed.
11. Once ALL the programming has been completed, then press the SET button. The
programming data that has been entered will now over-ride the factory built-in program and
operate your remote control system.
PROGRAM REVIEW
If you want to review the settings for either the FACTORY program and/or your CUSTOMIZED
program, you may do so by pressing the PROG button for one second. To review other
settings, press the PROG button allowing one second between each press of the PROG
button. If you press the PROG button for 4 seconds, then you go into the programming
process. Press the SET button should you hold the PROG button too long.
PROGRAM CANCELLATION
Should you want to cancel the CUSTOMIZED program that you have entered and return to the
FACTORY program, you may do so. To cancel a CUSTOMIZED program:
1. Press the SET button to make sure the LCD screen is in normal state.
2. Then press and hold the PROG button and, at the same time, press the SET button for a
period of 10 seconds.
3. The customized programs will be cancelled when the display icons/numbers flash with some