Operation Manual

ManualsBrandsSkytec ManualsAudioDMX Light Controller

NOTE : L-- refers to data information of CH1, CH2, CH3 and CH4 corresponding to 1, 2, 3 and 4

output.

R-- refers to data information of CH1, CH2, CH3 and CH4 corresponding to 4, 3, 2 and 1

output.

A.5. F + D/S BUTTONS ( Press F and D/S buttons at a time )

Press to select CRO or NOR.

NOTE : NOR refers to 0-100% dimming.

CRO denotes only FULL ON and STAND BY are available. When dimming level is greater

than 50%.

FULL ON is activated, otherwise, STAND BY is effective.

A.6. F + MODE BUTTONS

This function is effective only in MASTER mode.

A.7. F + PRESET BUTTONS

Press F + PRESET to select available parameter, adjust the selected parameter with UP and DOWN

buttons.

PARAMETER FUNCTION

F00-F99

FADE TIME ( 0-10S )

000-0FF

DIMMER ( 0-100% )

R01-R99

SPEED ( 1/60 STEP PER SECOND TO 20 STEP PER SECOND )

E00-E25

PRESET MINIMUM DIMMING LEVEL ( 0-25% )

P01-P16

PROGRAM ( 1-16 )

A.8. F + SIGNAL SELECT BUTTONS

Press to switch operating mode from DMX to MASTER mode, and the DISPLAY will show OUT.

A.9. F + SIGNAL SELECT + RESET BUTTONS

Press to perform a reset for the whole system, which enables to return to initial condition.

A.10. DMX indicator blinks when preheat is effective, otherwise lights.

A.11. SIGNAL indicator blinks when DMX signal is available and goes out when not available.

A.12. DISPLAY shows IN and channel indicators stop blinking after 10 seconds when operation is paused.

B. MASTER mode

When the MASTER indicator is on ( Press “F + SIGNAL SELECT” until DISPLAY shows OUT ), this unit

is used as a DMX chase controller.

B. 1. F + MODE BUTTONS

Press to select desired operating mode.

This function is effective only in MASTER mode. The operating modes are changed in order of:

MANUAL DIMMER

MANUAL PROGRAM AUTO PROGRAM

AUTO SOUND PROG SOUND HOLD SOUND

B. 1. 1. MANUAL DIMMER

Normally, the dimming level of all four channels are the same ( 0-100%, DISPLAY shows d00-dFF ).

Press F + PRESET buttons, dFF will shows on DISPLAY, press UP or DOWN can adjust the total

dimmer level.

Press one of buttons 1, 2, 3 and 4, corresponding indicator will blink, then select desired dimming

level using UP or DOWN button. These 4 buttons are effective only when MANUAL DIMMER

indicator is on.

Press F + RESET buttons to withdraw from this condition, the indicator won’t blink.

B. 1. 2. MANUAL PROGRAM

Press F + PRESET to select available parameter, adjust the selected parameter with UP and

DOWN buttons.