User Manual

19
Phenomenon
Defect
Reason
Measures
Misalignmen
t of fibers
1. V-groove is dirty
2. Motor stroke is
out of range
1.Use Cotton Swab and
Cleaved Fiber to clean the
V-groove.
2.Manually adjust fiber
position.
Fiber end
bevel angle
is too large
1.Poor fiber cut
1.Adjust the height of the
fiber cleaver blade.
(Video: youtu.be/eoDzTGHLg6w)
2. The fiber cleaver blade
is worn out, please rotate it
to a new position or replace
with a new fiber cleaver.
(Video: youtu.be/r8v-vGfuuGk)
The end of
the fiber has
burrs
Fiber end
face
protrusion
Blurred fiber
image
1.Camera is dirty
1.Clean the camera.
Defect
Reason
Measures
Cannot start the
machine
1. The battery is too low
2. No battery installed
3.The adapter has no power
1. Replace the battery or
charge the machine
2. Install the batteries in the
machine
3. Connect the power supply
to the adapter
Fiber is not
automatically spliced
after closing the cover
"Auto start" is closed
【
Splice Option
】
->
【
Operation Option
】
->Set
"Auto start" to "ON"
Does not heat up
automatically after
closing the heating
oven cover
"Heat Control" is
"Manual"
【Heater Mode】->Choose
the type of heat-shrinkable
tube->Set "Heat Control"
to "Auto"