User Manual

15
<2>Select 【Left Fiber】(Press and hold key to display positioning grid, hold
key to display menu, press and hold key to confirm selection); Press and hold
the button to move the fiber to the left position of the screen(As shown in figure
10.2.2).
<5>If it displays “Complete”, it means the calibration was successful.
Figure 10.2.1 Figure 10.2.2
9. Manually adjust the fiber position / Motor Calibration
(Video: youtu.be/u0oUbqNg77A)
Why do we need to adjust the position of the fiber?
Due to the dust on the construction site, the initial position of the motor
changed. When the fiber is welded, the motor stroke cannot reach the alignment
position, which leads to the wrong position of the fiber and welding cannot be
performed. After cleaning the dust in the V-groove, the fusion splicer still can not
be welded, so we need to manually adjust the position of the fiber to restore the
original position of the motor.
<1>Select 【Maintenance】-> 【Manufacture adjust 1】 -> Enter the
password "1" (The button selects the characters and the button confirms
the entry).
Figure 10.1.1 Figure 10.1.2 Figure 10.1.3