User Manual

15.Complete
13.Move the fiber to place the weld point in the
middle of the heat shrink tube.
14.Close the heater cover and start heating
12.Place the weld point of the fiber in the
center of the heat shrink tube.
The 900um tail
fiber is connected
with the leather
cable.
250μm bare fiber is
connected with 250
μm bare fiber.
①Open the wind cover and wait for the automatic reset of the fusion
splicer until the machine is at readiness status.
②Put respectively the prepared fibers into The bottom of
left and
right V grooves of the fusion splicer.
③
When the windproof cover is closed, the splicer will
automatically complete fusion between the following different kinds of
optical fibers.
●The application of different types of fibers in FTTH projects:
12
Splicing point