User's Manual

BATTERIES AND MAINTENANCE
VIDEO STUNT DRONE
OFF
O
N
3
4
3 x1.5 V AAA (LR03)
– AAA/LR03/R03 1.5V + – AAA/LR03/R03 1.5V +
+ AAA/LR03/R03 1.5V –
3
4
BB AA
AA
BB
FRONT
BACK
Bottom View of Mini Video Drone
GREEN
BLADES
BLACK
BLADES
Plug in USB cable
Red light = charging
Green light = fully charged
+ AAA/LR03/R03 1.5V – + AAA/LR03/R03 1.5V –
– AAA/LR03/R03 1.5V +
OFF
ON
• Lift joystick upward to
remove.
• Insert thumbstick into
stem to replace.
CHARGING PRECAUTIONS:
• After use, allow drone (battery on bottom) to cool down to room
temperature before charging again.
• Charge drone in an isolated area, away from excessive heat
or moisture.
• If you suspect that the battery is damaged or swelling, turn off the
drone immediately.
• Do not modify, heat, or wet the battery in any way. Only recharge with
provided charger.
1 Turn off the remote control & drone.
2 Plug the small end of the charging cord into
the back of the drone.
3 Plug the large end of the charging cord into
a computer or USB power block. Charge
battery until it is full.
1 Turn off drone.
2 Make note of the blade color and letter
(A or B) before removing the blade
from Drone. (Markings are located on
the underside of blades and Drone).
3 Pull up on the damaged blade
to remove.
4 Press on a new blade.
MAINTENANCE
• Over time, loose hair or carpet fibers may get wound in blades, reducing
performance. Unplug the Drone and remove fibers from motors. (Remove
blades if necessary)
OPTIONAL BLADE GUARDS
ALTERNATIVE
PRO THUMBSTICKS
Blade guards are great for beginning pilots and can be
easily installed if desired. The guards add undesired
weight and reduce flight performance.
Blade guards are optional and should not be used with
advanced flight sensitivity setting 3. To attach blade
guards, insert the posts of the blade guards into the holes
of the drone. Press in the posts to
lock into place.
• RC Video Drone
• USB Charging Cable
• Alternative Pro Thumbsticks
• Remote Control
• 4 Replacement Blades
• Micro SD Card
• Micro SD Card Adapter
CONTENTS REMOTE BATTERIES
REPAIRING DAMAGED BLADES
CHARGING THE DRONE
Loosen the screw in
the Remote Control
battery compartment
door with a Phillips
screwdriver and insert
batteries as shown.
Replace door and
tighten screw.
Plug in charging cord Turn off drone.